Loading ...
Loading ...
Loading ...
9
6. Mark the placement of the mounting holes.
7. Move the base out of the way. Drill mounting holes. Use a hammer
to tap in the supplied anchors into the mounting holes.
8. Fasten the base loosely to the wall as shown in Figure 1, using two
mounting screws. Place a level against the bottom of the base and
adjust until level, then tighten the screws. (Leveling is for appearance
only, and will not affect thermostat operation.)
9. Insert stripped, labeled wires into matching wire terminals. See
“Wiring Diagrams”, Figure 2.
CAUTION: Be sure exposed portions of wires do not touch other wires.
10. Tighten screws on terminal block. Gently tug on each wire to be
sure of proper connection. Double check that each wire is connected to
the proper terminal.
Loading ...
Loading ...
Loading ...