Dewalt DXPW3400PR PressuReady 3400 PSI at 2.5 GPM Powered Cold Water Gas Pressure Washer

Instructional Manual - Page 8

For DXPW3400PR.

PDF File Manual, 84 pages, Read Online | Download pdf file

DXPW3400PR photo
Loading ...
Loading ...
Loading ...
ENGLISH
6
WARNING: RISK OF HOT SURFACES
WHAT CAN HAPPEN HOW TO PREVENT IT
Contact with hot
surfaces, such as
engines exhaust
components, could
result in seriousburn.
During operation, touch
only the control surfaces
of the pressure washer.
Keep children away from
the pressure washer at
all times. They may not
be able to recognize the
hazards of thisproduct.
WARNING: RISK OF INJURY FROM LIFTING
WHAT CAN HAPPEN HOW TO PREVENT IT
Serious injury
can result from
attempting to lift too
heavy anobject.
The pressure washer is too
heavy to be lifted by one
person. Obtain assistance
from others beforelifting.
SAVE THESE INSTRUCTIONS FOR FUTURE USE
BATTERIES AND CHARGERS
The battery pack is not fully charged out of the carton.
Before using the battery pack and charger, read the
safety instructions below and then follow charging
proceduresoutlined. When ordering replacement battery
packs, be sure to include the catalog number andvoltage.
Your pressure washer uses a
DEWALT charger. Be sure
to read all safety instructions before using your charger.
Consult the chart at the end of this manual for compatibility
of chargers and batterypacks.
For all information regarding the battery pack or charger,
please call 1-800-4-
DEWALT (1-800-433-9258) or visit our
website www.dewalt.com. The battery pack and charger are
to be taken to an authourized DEWALT servicecenter.
Important Safety Instructions for All
Battery Chargers
WARNING: Read all safety warnings and all
instructions for the battery pack, charger and
pressure washer. Failure to follow the warnings
and instructions may result in electric shock, fire
and/or seriousinjury.
Before using the charger, read all instructions and
cautionary markings on the charger, battery pack
and product using the batterypack.
DO NOT attempt to charge the battery pack with
any chargers other than the ones in this manual.
The charger and battery pack are specifically designed to
worktogether.
These chargers are not intended for any uses other
than charging
DEWALT rechargeable batteries.
Any other uses may result in risk of fire, electric shock
orelectrocution.
Do not expose the charger to rain orsnow.
Pull by the plug rather than the cord when
disconnecting the charger. This will reduce the risk of
damage to the electric plug andcord.
Make sure that the cord is located so that it will not
be stepped on, tripped over or otherwise subjected
to damage orstress.
Do not use an extension cord unless it is absolutely
necessary. Use of improper extension cord could result in
risk of fire, electric shock orelectrocution.
When operating a charger outdoors, always provide
a dry location and use an extension cord suitable
for outdoor use. Use of a cord suitable for outdoor use
reduces the risk of electricshock.
An extension cord must have adequate wire size
(AWG or American Wire Gauge) for safety. The smaller
the gauge number of the wire, the greater the capacity
of the cable, that is, 16 gauge has more capacity than 18
gauge. An undersized cord will cause a drop in line voltage
resulting in loss of power and overheating. When using
more than one extension to make up the total length,
be sure each individual extension contains at least the
minimum wire size. The following table shows the correct
size to use depending on cord length and nameplate
ampere rating. If in doubt, use the next heavier gauge. The
lower the gauge number, the heavier thecord.
Minimum Gauge for Cord Sets
Volts
Total Length of Cord in Feet
(meters)
120 V 25 (7.6) 50 (15.2) 100 (30.5) 150 (45.7)
240 V 50 (15.2) 100 (30.5) 200 (61.0) 300 (91.4)
Ampere Rating
American Wire Gauge
More
Than
Not
More
Than
0 6 18 16 16 14
6 10 18 16 14 12
10 12 16 16 14 12
12 16 14 12 Not Recommended
Do not place any object on top of the charger or
place the charger on a soft surface that might block
the ventilation slots and result in excessive internal
heat. Place the charger in a position away from any heat
source. The charger is ventilated through slots in the top
and the bottom of thehousing.
Do not operate the charger with a damaged cord
orplug.
Do not operate the charger if it has received a sharp
blow, been dropped or otherwise damaged in any
way. Take it to an authorized servicecenter.
Do not disassemble the charger; take it to an
authorized service center when service or repair
is required. Incorrect reassembly may result in a risk of
electric shock, electrocution orfire.
Disconnect the charger from the outlet before
attempting any cleaning. This will reduce the risk of
Loading ...
Loading ...
Loading ...