Loading ...
Loading ...
Loading ...
ENGLISH
10
is no battery pack in the cavity. Unplug the charger
before attempting toclean.
6. Do not freeze or immerse the charger in water or any
otherliquid.
Storage Recommendations
NOTICE: DO NOT store battery pack in pressure
washer. ALWAYS turn unit off and remove the battery
pack beforestoring.
1. The best storage place is one that is cool and dry, away
from direct sunlight and excess heat orcold.
2. For long storage, it is recommended to store a fully
charged battery pack in a cool dry place out of the
charger for optimalresults.
NOTE: Battery packs should not be stored completely
depleted of charge. The battery pack will need to be
recharged beforeuse.
SAVE THESE INSTRUCTIONS FOR FUTURE USE
ASSEMBLY
Pressure Washer Assembly (Fig.A, C–F)
1. Slide the handle assembly
8
onto the frame
6
and
secure with saddle bolts
20
andknobs
21
.
Fig. C
8
6
20
21
22
20
21
8
2. Align holes in the top handle
22
with the mounting
holes in the handle assembly
8
. Insert saddle bolts
20
through aligned holes and secure top handle to handle
assembly with knobs
21
. Tighten untilsnug.
CAUTION: Risk of personal injury. Avoid placing
hands between handle and frame when assembling
to preventpinching.
3. Attach high pressure hose
9
to spray gun
3
. Make sure
it issecure.
Fig. D
9
3
4. Connect wand
5
to spray gun
3
. Make sure connection
issecure.
Fig. E
5
3
5. Remove the five colored quick-connect nozzles from the
plastic bag and insert them into correct grommet on the
nozzle holder. Nozzles are color coded to match colored
nozzles on panelassembly.
Fig. F
6. Check the tire pressure and add air if needed.
NOTE:Air tanks, compressors and similar equipment
used to inflate tires can fill small tires similar to these
very rapidly. Adjust pressure regulator on air supply to
no more than the rating of the tire pressure. Add air in
small increments and frequently use the tire gauge to
prevent overinflation.
WARNING: Risk of bursting. Use a tire pressure gauge
to check the tires pressure before each use and while
inflating tires; see the tire sidewall for the correct
tirepressure.
OPERATION
Pressure Adjustments
The pressure setting is preset at the factory to achieve
optimum pressure and cleaning. To lower the pressure,
follow theseinstructions.
1. Back away from the surface to be cleaned. The further
away the nozzle is, the less the pressure will be on the
surface to becleaned.
2. Change to the 40˚ nozzle (white). This nozzle delivers a
less powerful stream of water and a wider spray pattern.
Refer to Spray WandNozzles.
3. This pressure washer's high pressure pump is equipped
with an adjustable unloader
30
(Fig. G) feature that
allows the pressure setting to be adjusted. To lower the
pressure, turn the pressure control knob on the pump
counterclockwise to the desired pressure. To return the
pump pressure to the factory setting, turn the pressure
control knob on the pump clockwise until itstops.
NOTICE: DO NOT try to turn pressure regulator
knob past the built-in stop or damage to the pump
willresult.
NOTICE: DO NOT overtighten the pressure control
knob. If overtightened the knob COULD break and
result in immediate loss of water pressure and costly
repairs to theunit.
Loading ...
Loading ...
Loading ...