DCAM100
Installation
Instructions
System Description
SMART
DOORBELL
CAMERA
DOORBELL
TRANSFORMER
CHIME BOX
RETUOR iFiW
WiFi COMMUNICATIONS
CLOUD
SMARTPHONE
Doorbell Camera Components
POWER DRILL WITH 1/4” BIT
WIRE STRIPPERS / CUTTER
PHILLIPS SCREWDRIVER
LEVEL
FLAT SCREWDRIVER
OPTIONAL
PLIERS
Tools For Installation
DIODES FOR
CHIME BOX (2)
WIRE
CONNECTORS (4)
TORX
WRENCH
TORX SCREW
SMART
DOORBELL
CAMERA
SMART DOORBELL
CAMERA MOUNTING
PLATE
PHILLIPS SCREWS
(3)
ANCHORS
(3)
SMARTPHONE
EXISTING
DOORBELL
Prepare for Installation
•
Go to existing doorbell location.
•
Use a Smartphone connected to the installations WiFi
router to confirm adequate signal strength (2 - 3 bars).
Existing Doorbell Removal
DISCONNECT WIRES
FROM PUSHBUTTON
DOORBELL
•
Remove existing doorbell pushbutton from location.
•
Disconnect wires from back of pushbutton.
Mounting Doorbell Camera Plate
OR
USE 1/4" (6.35mm) DRILL FOR
ANCHOR HOLES
SCREWS ONLY SCREWS & ANCHORS
• Use mounting plate as guide to mark holes.
• Use leveling tool to align mounting plate.
Wiring Doorbell Camera
1. TWIST THEN
FEED WIRES INTO
SHORT END OF
CONNECTOR
2
. CRIMP WIRES
WITH PLIERS ON
SHORT END OF
CONNECTOR
CONNECTORS IN PLACE
• Connect doorbell wires using weather-resistant wire connectors (included).
• Ensure there is enough room behind the mounting plate for excess wires.
System Overview
CHIME BOX
DOORBELL TRANSFORMER
REAR
TRANS
FRONT
REAR TRANS
FRONT
1 OPEN CHIME BOX
CHIME BOX
FRONT VIEW
WITHOUT COVER
2 INSTALL DIODE AS SHOWN
IMPORTANT STEP
Installing Diode in Chime Box
3
NOTE: Not
compatible
with
electronic
chimes
1 2
4
5
VERIFY WiFi STRENGTH
NOTE: It is recommended to TURN POWER OFF
before performing any wiring.
6
Status
Power ON
Flashing Blue once
Cold start at low temperature Flashing Blue (Slow)
Connect to 16V transformer without diode
Solid Blue 5 seconds
1. Occurs after power on, or push the button
2. Can’t ring the chime box
The voltage of transformer is low
Flashing Blue
5 seconds (fast)
1. Occurs after power on, or push the button
2. Proceed to Step 7.
Solid Blue Doorbell can’t work
LED Indicators Status
The voltage of transformer is too high
Note
Color
NOTE:
When (2)
DCAM100’s are used,
connect a second diode
between REAR and
TRANS terminals.
NOTE:
Ensure there is
enough room behind the
mounting plate for excess
wires.
Solid Red
Powering up
Flashing Green (Fast)
Connecting to Cloud Server
Solid Green
Connected to Cloud Server
Flashing Green (Slow)
Session in Progress
Flashing Red (Slow)
Not connected to network
Flashing Red (Fast)
Firmware update
Skip Step 7 and proceed to Step 8.
Flashing Green/Red
Discovery Mode
Skip Step 7 and proceed to Step 8.
Loading ...
Loading ...
Loading ...
