Loading ...
Loading ...
Loading ...
ERROR CODES
If an abnormality comes up, the hob will automatically enter a protective state and display corresponding
protective codes:
AFTER SALES SERVICE 1300 307 917
Problem Possible causes What to do
E1 Signal lost (PCB failure) Please contact after sales service
E2/E3
Abnormal High/Low input voltage
Stop cooking and wait until input voltage back to normal. If
not, please contact after sales service.
E4/E5/E6 Thermistor failure. Please contact after sales service to repair.
E7 Abnormal high temperature
(dry burning)
Cut o power, wait for 30min and switch on.
If still not working, please contact after sales service.
E8/E9
Failure of IGBT sensor Please contact after sales service to repair.
E0 IGBT Overheat
Check if the fan is still working. If not, please contact after
sales service.
EE Display PCB failure. Please contact after sales service.
The above are the judgment and inspection of common failures.
ATTENTION! To avoid danger, please do not disassemble the unit by yourself!
INSTALLATION
Preparation of the kitchen bench
1. Be sure the thickness of the kitchen bench is at least 30mm.
2. A suitable heat-resistant kitchen bench material must be used to avoid deformation caused by the heat
radiation from the cooktop.
3. When installing a minimum clearance of 50mm must be preserved around the hole in the bench.
4. Cut out the work surface according to the sizes shown in the drawing. Be accurate!!
Model L(mm) W(mm) H(mm) D(mm) A(mm) B(mm) X(mm)
GLINDBG 590 520 62 58 560 490 50 mini.
GLINDPS 590 520 62 58 560 490 50 mini.
ATTENTION: Ensure that the cooktop is well ventilated underneath, and the air inlet and outlet are not
blocked. Ensure that the cooktop works well. It is the installer’s responsibility to ensure that that the cooktop
is adequately sealed. No warranty claims will be accepted for benches damaged because of moisture
leaking through the seal or insucient ventilation.
The distance between the cooktop surface and the cupboards above should not be less than 760mm - refer
to diagram on the next page.
Loading ...
Loading ...
Loading ...