Loading ...
Loading ...
Loading ...
sharkclean.comsharkclean.com
If you run over a hard or sharp object or notice a noise change while vacuuming, check for blockages or
objects caught in the brushroll.
Checking for Blockages in the Hand
Vacuum:
1. Turn o the vacuum.
2. Remove the hand vacuum from the wand.
3. Check all intake openings to the
dust cup and remove any debris or
blockages.
Checking for Blockages
in the Charging Post:
1. Unplug the dock.
2. Remove the vacuum from the dock.
3. Press the latch o the side of the
charging post and lift away from
the dock base.
4. Check the end of the charging
post and top of the dock base
for any debris or blockages.
Checking for Blockages in the Wand:
1. Turn o the vacuum.
2. Detach the hand vacuum and floor
nozzle from the wand.
3. Check both ends of the wand for
blockages and debris.
4. Clear away any debris or blockages.
Checking for Blockages in the Dock:
1. Unplug the dock.
2. Remove the vacuum from the dock.
3. Remove the dust bin from the dock.
4. Check the exit for any debris
or blockages.
Checking for Blockages in the Floor
Nozzle:
1. Turn o the vacuum.
2. Detach the wand.
3. Using a coin, turn the 3 locks on the
bottom of the nozzle counterclockwise
to open.
4. Lift o the nozzle cover and tilt
back the neck of the nozzle.
5. Check the opening and remove
any debris.
6. Replace the cover by sliding the tabs
into the slots. Press down firmly on all
sides. Turn the locks clockwise to close.
CHECKING FOR BLOCKAGES IN THE VACUUM
CHECKING FOR BLOCKAGES IN THE DOCK
MAINTAINING YOUR VACUUM
MAINTAINING YOUR VACUUM
4. Clear any blockages and remove any debris
from the brushroll and floor nozzle.
5. With the cover removed, wipe the brushroll
clean with a dry towel.
6. Replace the cover by sliding the tabs into the
slots. Press down firmly on all sides. Turn locks
clockwise to close, until they click into place.
NOZZLE MAINTENANCE
POWERFIN FLOOR NOZZLE
1. Turn o the vacuum.
2. Press the nozzle release button to detach the
nozzle from the wand.
3. Using a coin, turn the 3 locks counterclockwise
to open, then lift o the cover and tilt back the
neck of the nozzle.
For best results, regularly clean and replace the filters in the dock base. To clean filters, rinse with cold water ONLY
to prevent damage from cleaning chemicals. Allow all filters to air-dry for at least 24 hours before reinstalling them
to prevent liquid from being drawn into electrical parts.
CLEANING DOCK FILTERS
To access the pre-motor filter, lift up the cover
on the top left side of the dock base. Lift out the
foam filter by the handle then remove the felt filter
underneath. Tap the filters over the trash, then rinse
with cold water. Allow the filter to air-dry for 24
hours before reinstalling.
To access the post-motor filter, press the button at
the top of the filter door, then tilt the door away from
the dock and lift. Remove the Post-Motor Filter from
the base. To reinstall the post-motor filter, insert it
into the base and replace the filter door.
Press
Loading ...
Loading ...
Loading ...