Loading ...
Loading ...
Loading ...
20
Step-by-step installation guide
5. Rotate blower unit counterclockwise 180°.
Before Rotation After Rotation
Back of Microwave Back of Microwave
6. Place the blower unit back into the opening.
AFTER: Fan Blade
Openings Facing Back
End B
End A
CAUTION: Do not pull or stretch the blower unit
wiring. Make sure the wires are not pinched.
NOTE: The blower unit exhaust openings should
match exhaust openings on rear of microwave
oven.
7. Replace the blower plate in the same position as
before with the screw.
8. Close the blower door. Slide blower shield onto the
top of the blower door opening. Secure the blower
to the microwave oven using the blower retaining
screws from Step 1 except the upper blower motor
retaining screw.
Blower
Retaining Screw
Blower Shield
Blower
Retaining Screw
Back of
Microwave Oven
9. Slide the exhaust adaptor onto the back of the
microwave oven, securing it into the lower locking
tabs. Take care to ensure that the damper hinge is
installed so that it is at the top and that the damper
swings freely. Reinstall the upper blower motor screw
through the adaptor and the blower door and into
the back of the microwave oven.
Guide
Guide
Adaptor Locking Tabs
(not shown)
Blower Motor Door
Retaining Screw
Back of
Microwave Oven
C5. MOUNT THE MICROWAVE OVEN
FOR EASIER INSTALLATION AND PERSONAL SAFETY,
WE RECOMMEND THAT TWO PEOPLE INSTALL THIS
MICROWAVE OVEN.
IMPORTANT: Do not grip or use the handle during
installation.
NOTE: If your cabinet is metal, use the nylon grommet
around the power cord hole to prevent cutting of the
cord.
NOTE: We recommend using filler blocks if the cabinet
front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used, case
damage may occur from over tightening screws.
NOTE: When mounting the microwave oven, thread
power cord through hole in bottom of top cabinet.
Keep it tight throughout Steps 1-3. Do not pinch cord or
lift oven by pulling cord.
1. Lift microwave, tilt it forward,
and hook slots at back
bottom edge onto four lower
tabs of mounting plate.
2. Rotate front of
oven up against
cabinet bottom.
3. Insert a self-aligning screw through the top center
cabinet hole. Temporarily secure the oven by turning
the screw at least two full turns after the threads
have engaged. (It will be completely tightened later.)
Be sure to keep power cord tight. Be careful not
to pinch the cord, especially when mounting
flush to bottom of cabinet.
OTR_II_DE68-03587B-07_EN+CFR.indb 20OTR_II_DE68-03587B-07_EN+CFR.indb 20 2022-01-20 10:11:562022-01-20 10:11:56
Loading ...
Loading ...
Loading ...