Loading ...
Loading ...
Loading ...
UNPACKING
This product has been shipped completely assembled.
• Carefully remove the tool and any accessories from the
box. Make sure that all items listed in the packing list
are included.
• Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
• Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
• If any parts are damaged or missing, please call
1-800-932-3188 for assistance.
PACKING LIST
3.6V Cordless Screwdriver
Charger & Charging Stand
2 Screwdriver Bits
Operator's Manual
WARNING: If any parts are missing do not operate
this tool until the missing parts are replaced. Failure
to do so could result in possible serious personal
injury.
WARNING: Do not attempt to modify this tool
or create accessories not recommended for use
with this tool. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
_ WARNING: To prevent accidental starting that
could cause serious personal injury, always remove
the battery pack from the tool when assembling
parts.
,_ WARNING: Do not allow familiarity with tools to
make you careless. Remember that a careless
fraction of a second is sufficient to inflict serious
injury.
,_ WARNING: Always wear safety goggles or safety
glasses with side shields when operating tools.
Failure to do so could result in objects being thrown
into your eyes, resulting in possible serious injury.
APPLICATIONS
You may use this tool for the following purposes:
• Using driving accessories, such as driving screws with
screwdriver bits.
• Light-duty drilling
CHARGING THE SCREWDRIVER
This tool has been shipped in a low charge condition to
prevent possible problems. Therefore, you should charge
it overnight prior to use.
NOTE: Batteries will not reach full charge the first time
they are charged. Allow several cycles (driving screws
followed by recharging) for them to become fully charged.
If the charger does not charge the screwdriver under
normal circumstances, return both the screwdriver and
charger to the nearest Sears Service Center for electrical
check.
TO CHARGE SCREWDRIVER WITHOUT
USING CHARGING STAND
See Figure 3.
• Insert charger plug into input jack making sure they are
properly connected.
• Charger can be used with normal household volt-
age of 120 volts, 60 Hz, AC only.
• Connect charger to power supply.
• After normal usage, a minimum of 10 hours of charging
time is required to fully charge screwdriver.
• Do not place charger in an area of extreme heat or
cold. It will work best at normal room temperature.
/ i CHARGER
INPUTJACK \\\\
CHARGERPLUG
Fig. 3
10
Loading ...
Loading ...
Loading ...