Loading ...
Loading ...
Loading ...
6
OPERATING INSTRUCTIONS
Safety Check List
Always Perform this Step Before Use to Ensure Safe Operation
1. Check that the 2 vent plugs in the rear case are in good condition, are fully
seated and the white GORE-TEX
®
material has not previously been dislodged.
WARNING: if the plugs are out of position or the white material is missing
or loose, this means that the venting system has been activated and the
batteries are damaged. IMMEDIATELY take the unit out of service, and
send it to Clore Automotive for repair. See Warranty Section for details.
2. Check to make sure that the Voltage Selector Switch is in the OFF position.
3. Check to make sure that the clamps and cables are in good working order.
Signs that the clamps may be damaged include, but are not limited to the
following:
- Burn Marks on the Jaws
- Damaged clamp handles
- Damaged clamp springs
- Damaged cables where copper wiring may be exposed (insulation jacket
deteriorated, cut or missing)
4. Check to make sure the case is not swollen (a sign of damaged batteries).
5. Check to make sure the holsters (where the clamps should be stored) are in
good condition. These are designed to ensure that the clamps cannot come in
contact with each other, or come in contact with a common conductor.
Verifying these 5 simple check points before every use will keep your Truck PAC safe
to use and increase its service life.
Used as an Emergency Jump Starter
Note: For optimum performance, do not store your Truck PAC below 50° when using
as a jump starter. Never charge or jump start a frozen battery.
Advanced Warning System (AWS)
TM
– HAZARD WARNING FEATURE
Your Truck PAC is equipped with our AWS – Advanced Warning System – designed to
provide an advanced alert to common jump starting mistakes. Your Truck PAC
contains a buzzer which will sound an audible alarm if the Advanced Warning System
detects specific undesirable conditions during the jump starting process.
If the AWS Detection Alarm sounds at any time during the jump starting process,
disconnect the Truck PAC from the vehicle immediately! Always remember to practice
jump starting safety and disconnect the ground clamp first.
WARNING
Never hook up a 12 Volt DC power source to a 24 Volt DC vehicle. This will grossly
overcharge the 12 Volt power source and generate flammable gasses that may explode
and cause property damage and/or bodily harm.
Loading ...
Loading ...
Loading ...