Loading ...
Loading ...
Loading ...
8
AJ600
Injector Cleaner & Tester
ANCEL
Procedures:
Installation refer to Uniformity/ Sprayability Test.
1) Before this test, press DRAIN icon to drain the test liquid from the measuring cup if there is any.
2) Choose Injecting Flow Test function and press Run key to start the test.
Adjust the fuel pressure by pressing
+
or
–
key according to the injector specification.
3) When the test is over, the equipment will stop automatically at the ring of the buzzer.
5.6 Auto. Test
Auto. test contains all above-mentioned tests (15-second injecting test, idle speed, middle speed, high speed, varying
acceleration, varying deceleration, changing pulse width test). This function can test more comprehensive
performance of injectors by simulating the various engine working conditions.
Procedures:
Installation refer to Uniformity/ Sprayability Test.
1) Before the test, press DRAIN icon to drain all the test liquid in the measuring cups if there is any.
2) Select AUTO function choose mode no. , then press Run key to start the test.
3) Adjust the fuel pressure by pressing + or – keys.
4) When the test is over, the equipment will auto stop at the ring of the buzzer.
There are 3 modes for auto. test: Mode 1, Mode 2 and Mode 3. Mode 1 and Mode 2 are shown below, while Mode 3
is to run Mode 2 after running Mode 1.
Mode 1
Mode 2
Loading ...
Loading ...
Loading ...