Loading ...
Loading ...
Loading ...
38
Place the machine on a clean, hard, level surface, free from unwanted material or other objects that may
hamper your ability to move freely. A rubber mat can be used below the machine to prevent the release of
static electricity and protect your ooring.
The machine can be moved by one or more persons. Make sure that your own physical strength is capable
of safely moving the machine.
2. Examine for any objects below the Pedals. Be sure it is clear.
3. Connect the power cord to the machine and into a grounded AC Wall Outlet.
4. If you use a Heart Rate Monitor, follow the Heart Rate Monitor directions.
5. To mount the machine, move the Pedals so both are over the Rail Assembly, and not extended past the rear of the
machine.
Care should be used when mounting or dismounting the machine.
Be aware that the Pedals and the Handlebars are connected and when either of these parts move the other
does as well. In order to avoid possible serious injury, grasp the Static Handlebars to steady yourself.
6. Grasp the Static Handlebars under the Console Assembly.
7. Steadying yourself with the Static Handlebars, step up onto the Transport Handle / Rear Step and the lowest Pedal.
As your weight is applied to the lowest Pedal, both Pedals will move. Be sure that the Pedals do not affect the leg on
the Transport Handle / Rear Step.
Note: “Bottomed out” is when the User is unable to start a workout because the Pedals will not move. If this occurs,
safely grasp the Static Handlebars and apply your weight to the heel of the higher foot. While still grasping
the Static Handlebar, lean back slightly applying more weight onto the heel. Once the Pedals begin to move,
resume your intended workout.
8. You are now in position to begin a workout.
Power-Up / Idle Mode / Welcome screen
The Console will enter Power-Up / Idle Mode if it is plugged into a power source, any button is pushed, or if it receives a
signal from the RPM sensor as a result of pedaling the machine.
Auto Shut-O (Sleep Mode)
If the Console does not receive any input in approximately 5 minutes, it will automatically shut o. The LCD display is o
while in Sleep Mode.
Note: The Console does not have an On/Off switch.
Manual (Quick Start) Program
The Manual (Quick Start) program lets you start a workout without entering any information.
During a Manual Workout, each column represents a 1 minute time period. The active column will advance across the
screen every minute. If the workout lasts for more than 18 minutes, the active column will stay to the right where an
additional column is added to the workout program.
1. Mount the machine.
2. Push Start to begin the workout.
To change the resistance level, push the Resistance Increase/Decrease buttons. To change the incline level, push
the Incline Increase/Decrease buttons. The current interval and future intervals are set to the new level. The default
Manual resistance level is 4. The default Incline level is 0. The time will count up from 00:00.
Loading ...
Loading ...
Loading ...