Loading ...
Loading ...
Loading ...
,Step-13B
3A3,Upper Cable assembly instruction Step-1 Step-1
A.) Remove the U-shaped Connector, Big Washer, and Ball Stopper from one end of the
229“Upper Cable (#41).
B.) Insert this End through the left Cross-over Swivel Pulley Bracket (#99). Attach a Pulley (#57)
to the Swivel Bracket and secure it with one M10 x 1 ¾” Allen Bolt (#69), two Ø ¾” Washers
(#66), and one M10 Aircraft Nut (#86). Draw the Cable over the Pulley and pull it toward the
back of the machine.
C.) Draw the Cable along the Left Upper Frame (#94) to the opening on the rear of the Left Upper
Frame. Drop the Cable through the opening.
D.) Attach a Pulley to the opening. Secure it with one M10 x 2 ½” Allen Bolt (#70), two Pulley
Bushings (#62), and one M10 Aircraft Nut (#86). Draw the Cable around the Pulley then
downward.
E.) Attach a Single Small Pulley Bracket (#98) to the bracket underneath the Rear Upper Frame
(#9). Secure it with one M10 x 1” Allen Bolt (#68) and one M10 Aircraft Nut (#86).
F.) Attach two Small Pulleys (#103) to the Triple Floating Pulley Bracket (#96). Secure them with
one M10 x 2 ¾” Allen Bolts (#105), two Ø ¾” Washers (#66), and one M10 Aircraft Nut (#86).
Draw the Cable around the front Small Pulley (closer to Butterfly) then upward to the Single
Small Pulley Bracket (#98) installed in Procedure E. Attach a Small Pulley (#103) to the Small
Pulley Bracket (#98). Secure the Small Pulley with one M10 x 1 ¾” Allen Bolt (#69), two Ø ¾”
Washers (#66), and one M10 Aircraft Nut (#86).
G.) Draw the Cable around the Small Pulley then downward to the Triple Floating Pulley Bracket.
Draw the Cable around the Small Pulley (closer to the Sliding Weight Post) then upward to the
opening on the rear of Right Upper Frame (#95). Let the Triple Floating Pulley Bracket
hanging for now.
H.) Attach a Pulley to opening on the rear of Right Upper Frame. Secure it with one M10 x 2 ½”
Allen Bolt (#70), two Pulley Bushings (#62), and one M10 Aircraft Nut (#86). Draw the Cable
over the Pulley along the top of the right Cross-over Swivel Pulley Bracket. Attach a Pulley
(#57) to the Swivel Bracket and secure it with one M10 x 1 ¾” Allen Bolt (#69), two Ø ¾”
Washers (#66), and one M10 Aircraft Nut (#86).
I.) Re-install the Ball Stopper, Big Washer, and the U-shaped Connector removed in Procedure A
above. Secure this end and the other end of Cable with one M10 x 1 ⅛” Allen Bolt (#104) and
one M10 Aircraft Nut (#86).
J.) Connect a Single Handle Strap (#90) to each end of the Cable with a C-clip (#61).
K.) When using the Lat Bar (#29), remove one of the Single Handle Strap and connect the Lat Bar
to the Cable end with a Short Chain (#63) and two C-Clips.
©IMPEX INC.
12
www.marcypro.com
Loading ...
Loading ...
Loading ...