Loading ...
Loading ...
Loading ...
TO A'FFACH JUMPER CABLES -
o Connect each end of the RED cable to
the POSITIVE (+) terminal of each bat-
tery, taking care not to short against
chassis.
o Connect one end of the BLACK cable to
the NEGATIVE (-) terminal of fully
charged battery°
Connect the other end of the BLACK
cable to good CHASSIS GROUND,
away from fuel tank and battery,
TO REMOVE CABLES, REVERSE
ORDER -
BLACK cable first from chassis and
then from the fully charged battery,
Positive Terminal Negative Terminal
° Connect BLACK grounding cable to
negative (-) terminal with remaining hex
bolt, flat washer, lock washer and hex
nut. Tighten securely.
o Close battery box door.
Seat Pan
Battery
Door Box
LeckWasher
Flat
Hex Washer
Nut Hex
Belt
Positive (Red) Cable
Negative (Black)
Cable
Charged
Battery
Positive Terminal
Negative Terminal
REPLACING BATTERY
,&CAUTION: Do not short battery ter-
minals by allowing a wrench or any
other object to contact both terminals
at the same time. Before connecting
battery, remove metal bracelets, wrist-
watch bands, rings,etc.
Positive terminal must be connected
first to prevent sparking from acciden-
tal grounding.
° Lift seat pan to raised position and open
battery box door.
Disconnect BLACK battery cable first
then RED battery cable and carefully
remove battery from tractor.
o Install new battery with terminals in
same position as old battery.
° First connect RED battery cable to posi-
tive (+) terminal with hex bolt, flat wash-
er and hex nut as shown. Tighten
securely.
TO REPLACE HEADLIGHT BULB
o Raise hood.
o Pull bulb holder out of the hole in the
backside of the grill°
Replace bulb in holder and push bulb
holder securely back into the hole in the
backside of the grill.
° Close hood.
iNTERLOCKS AND RELAYS
Loose or damaged wiring may cause your
tractor to run poorly, stop running, or pre-
vent it from starting.
= Check wiring. See electrical wiring dia-
gram in the Repair Parts section of this
manual.
TO REPLACE FUSE
Replace with 30 amp automotive-type
plug-in fuse. The fuse holder is located
behind the dash.
26
Loading ...
Loading ...
Loading ...