Loading ...
Loading ...
Loading ...
If"jumpercables"are usedforemergency
starting,followthisprocedure:
IMPORTANT:Yourtractorisequipped
with a 12voltsystem.Theothervehicle
mustalsobe a 12voltsystem.Do not use
yourtractorbatteryto start othervehicles.
TOATTACHJUMPERCABLES-
1. Connectoneendof theREDcable
to the POSITIVE(+)terminalof each
battery(A-B),takingcare notto short
againsttractorchassis.
2. Connectoneendof theBLACKcable
to the NEGATIVE(-)terminal(C)of
fully chargedbattery.
3. Connecttheotherendof the BLACK
cable(D)to goodchassisground,
awayfromfuel tankandbattery.
TO REMOVE CABLES, REVERSE
ORDER -
1. BLACK cable first from chassis and
then from the fully charged battery.
2. RED cable last from both batteries.
Weak or Dead Battery Fully Charged Battery
REPLACING BATTERY
_,WARNING: Do not short battery
terminals by allowing a wrench or any
other object to contact both terminals at
the same time. Before connecting battery,
remove metal bracelets, wristwatch bands,
rings, etc.
Positive terminal must be connected
first to prevent sparking from accidental
grounding.
1. Lift seat pan to raised position.
2. Disconnect BLACK battery cable first
then RED battery cable and carefully
remove battery from tractor.
3. Install new battery with terminals in
same position as old battery.
4. First connect RED battery cable to
positive (+) terminal with hex bolt and
keps nut as shown. Tighten securely.
Slide terminal cover over terminal
5. Connect BLACK grounding cable to
negative (-) terminal with remaining hex
bolt and keps nut. Tighten securely.
27
Terminal
Keps
Nu
Hex
Bolt
Positive (Red) Cable Negative (Black) Cable
TO REPLACE HEADLIGHT BULB
1. Raise hood.
2. Pull bulb holder out of the hole in the
backside of the grill.
3. Replace bulb in holder and push bulb
holder securely back into the hole in
the backside of the grill.
4. Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause
your tractor to run poorly, stop running, or
prevent it from starting.
• Check wiring. See electrical wiring
diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 20 amp automotive-type
plug-in fuse. The fuse holder is located
behind the dash.
TO REMOVE HOOD AND GRILL AS-
SEMBLY
1. Raise hood.
2. Unsnap headlight wire connector.
3. Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of
tractor.
4. When replacing hood, be sure to re-
connect the headlight wire connector.
Hood
adlight Wire
nnector
Loading ...
Loading ...
Loading ...