Ancona AN-1323 User Manual

Loading ...

— 11 —

Installation

STEP 6

Preparations

NOTE: To avoid damage to your hood, prevent debris from entering the vent opening.

• Determine and mark the centre line on the ceiling or wall where the range hood will be installed.

• Make sure there is proper clearance within the ceiling or wall for exhaust vent.

• Duetotheweightandsizeofthisunit,pleasemakesurethatthesupportsystemorframeworkbeingusedisstableand

secure in the ceiling or wall.

• Put a thick, protective covering over counter top, cooktop or range to protect from damage or dirt.

• Removeanyhazardousobjectsaroundtheareawheninstalling.

CAUTION

If moving the cooking range is necessary to install the hood, turn OFF the power on an electric range at the main

electrical box. SHUT OFF THE GAS BEFORE MOVING A GAS RANGE.

Figure #1

STEP 7

Preparing the cabinet

• Measure and cut an opening at the bottom of the cabinet

to t the motor box of the range hood. (See Figure #1)

• Measure and cut a hole in the top of cabinet to t the duct

tube. (See Figure #1)

• Note that the hole in the top of the cabinet may not be

necessary depending on venting method chosen. (See

Page 10).

STEP 8

Attaching damper

• Attach the vent/damper to the top of the motor using

supplied screws. (See Figure #2).

Figure #2

Cut-out dimensions:

28 in.: 26.25 in. x 10.25 in.

(67 cm x 26 cm)

36 in.: 34.25 in. x 10.43 in.

(87 cm x 26.5 cm)

For consumer safety reasons, mounting

screws and anchors have not been supplied

with this range hood. Different wall and

cabinetry construction methods require

specic types of screws and wall anchors.

Please consult your installation specialist

regarding the best type of mounting screws

and wall anchors to suit your home’s

construction.

Loading ...

Ancona AN-1323 36 in. Insert B336D 420 CFM Ducted Range Hood