Loading ...
Loading ...
Loading ...
re and (;leaning
Co&toplight/
nightlight
To replace the cooktop light/
night light, first disconnect the
power at the main fllse or circuit
breaker panel.
.
Remoxe the screw from the
side of the light compartment
coxer and lower the coxer until
it stops.
3. Be sure the bulb to be replaced is
cool before remoxing. Gently pull
the bulb flom the receptacle.
Re[dace with 120 roll, 20 watt (max.)
halogen bulb. O'_ler WB36X102 l 3,f!om
your (;E ._ul)pli_,_:H_,&-int_,nsil_, 20 watt
bulbs, available in su/wrma'd'el._ and
hardware ._to_>_;may a£o be u._edjbr
?gJ) l(l('('llZ('ll, g5.
4. Raise the light coxer and replace
the screw. Connect electrical
power to the oxen.
Pu?usable vent
.filters
The metal filmrs trap grease released
by foods on the cooktop. They also
prevent flames from foods on the
cookmp flom damaging the inside
of the oven.
For this reason, the filters must
always be in place when the hood
is used. The xent filters should be
cleaned once a month, or as needed.
Removing and
cleaning the
filters
To remove, slide them to the rear
using the tabs. Pull down and ont.
To clean the vent filters, soak them
and then swish around in hot wamr
and demrgent. Don't use ammonia
or ammonia products because
they will darken the metal. Light
brushing can be used to remove
embedded dirt.
Rinse, shake and let d_wbefore
replacing.
To replace, slide the fihers into the
flame slots on the back of each
opening. Press up and to the front
to lock into place.
41
Loading ...
Loading ...
Loading ...