Loading ...
Loading ...
Loading ...
22
www.insigniaproducts.com
INSTALLATION INSTRUCTIONS
1 Remove the two rear exhaust retaining screws, then pull out the exhaust duct.
2 Press the tabs on the knockout, then carefully remove the knockout for the
desired vent opening.
3 Push the adapter duct onto the blower housing of your dryer.
4 Connect a 4 in. (10.2cm) elbow to the 4 in. (10.2cm) duct section, and secure
all joints with duct tape. Make sure that the male end of the elbow faces away
from your dryer.
5 Insert the elbow/duct assembly through the side opening and press it onto
the adapter duct. Secure in place with duct tape. The male end of the duct
should protrude 1.5 in. (3.8 cm) out of your dryer to connect the remaining
ductwork.
6 Attach duct tape to the back of your dryer to seal the original dryer vent hole.
Retaining screw
Rear exhaust duct
Adapter duct
Knockout
DRYER SIDE/BACK VIEW
Blower housing
Elbow
Duct tape
1 1/2 in. (3.8 cm)
Loading ...
Loading ...
Loading ...