Loading ...
Loading ...
Loading ...
48
Spirit Fitness
TROUBLESHOOTING
PROBLEM CAUSE
Display does not light 1. Tether cord not in position.
2. Circuit breaker on front grill tripped. Push circuit breaker in until it locks.
3. Plug is disconnected. Make sure plug is rmly pushed into115 VAC wall outlet.
4. Breaker panel circuit breaker may be tripped.
Treadbelt does not stay centered Treadmill belt
hesitates when walked/run on
The user may be walking while favoring or putting more weight on either the left or right foot. If this walking pattern
is natural, track the belt slightly off-center to the side opposite from the belt movement. See General Maintenance
section on Treadbelt Tension. Adjust as necessary.
Motor is not responsive after pressing start Reset power. If still unresponsive, contact service.
Circuit breaker trips, but not the treadmill circuit
breaker
Need to replace the breaker with a “High in-rush current” type breaker (see page 4 for details)
Treadmill will only achieve approximately 7 mph
but shows higher speed on display
This indicates motor should be receiving power to operate. Do not use an extension cord. If an extension cord is
required, it should be as short as possible and heavy duty, 16-gauge minimum, low voltage. Contact an electrician
or your Spirit Fitness dealer. A minimum of 110-volt AC current is required.
Treadbelt stops quickly/suddenly when tether
cord is pulled
High belt/deck friction. See General Maintenance section on cleaning the deck. If cleaning doesn’t prevent this
from reoccurring, check to see if there is signicant wear of the deck. If so, the deck may need to be ipped if it is
on its original side.
Treadmill trips on board 20 amp circuit High belt/deck friction. See General Maintenance. If cleaning doesn’t prevent this from reoccurring, check the amp
draw of the motor. If this is high and there are signs of signicant wear of the deck, it may need to be ipped on its
original side.
Computer shuts off when console is touched
(on a cold day) while walking/running
Treadmill may not be grounded. Static electricity is crashing the computer. Refer to Grounding Instructions.
Loading ...
Loading ...
Loading ...