Loading ...
Loading ...
The selection of a proper mounting location for your air source kit will help ensure a
long and trouble free service life. Please pay close attention to the following
guidelines:
1. Select a FLAT AND SECURE location where the air source kit can be mounted.
2. To maximize air compressor performance, locate compressor as CLOSE TO THE
BATTERY as possible so that length of positive lead wire required is at a minimum.
3. Choose mounting location that is as cool as possible and AWAY FROM HEAT SOURCES.
The cooler the ambient temperature the less chance the compressor will overheat.
4. The compressor is moisture & splash resistant, but NOT WATERPROOF. Do not mount
air source kit in locations where the unit is likely to come in contact with water.
5. If it is necessary to mount the air compressor further away from the battery, such
as inside your vehicle or in the bed of your pickup, use a minimum 8-10 AWG positive lead
wire for remote installation.
6. Do not mount air source kit near areas where flammable liquids are stored.
MOUNTING AND WIRING
1. Disconnect ground cable from vehicle’s battery.
2. Temporarily position the air source kit in the location where it will be mounted.
3. Route ground wire to the negative post of the battery or to an appropriate
grounding point
and cut ground wire to length as needed.
4. Mount air source kit at tank leg mounts with the four grommets, and four sets of
bolts, nuts, washers, and locking washers provided. Use of thread sealant is
recommended.
5. Route air line to the 1/4” compression fitting and make your air line connection.
Tighten compression fitting nut securely using a wrench.
6. Connect ground (Black) wire to a clean ground, (preferably a chassis ground) and
secure with a self-tapping screw.
7. Connect positive (Red) lead wire from preinstalled pressure switch to a fuse holder
(25- amp minimum).
Loading ...
Loading ...
Loading ...