Loading ...
Loading ...
Loading ...
8ninjakitchen.com7
1-877-646-5288
1 Programmable Digital Clock
2 Hour & Minute Buttons
3 Stay Warm Indicator/Button
(not available on all models)
4 Delay Brew Button
5 Multi-Serve Dial
a Cup
b XL Cup
c Travel Mug
d XL Multi-Serve
e Half Carafe
f Full Carafe
6 Custom Brews
a Classic Brew
b Rich Brew
c Over Ice Brew
7 Signature Brew
Specialty Brew
8 Drip Stop Indicator
9 Intelligent Clean Cycle
Indicator/Button
10 Power Button
1 When the unit is plugged in, the clock will flash on
the control panel to indicate that the time has not
been set�
2 Press the hour (H) or minute (M) button until you reach
the current time� The AM or PM indicator will illuminate
on the left side of the display as you are setting the time�
3 After 5 seconds, the clock will stop flashing and the
clock will be set�
NOTE: If the clock stops flashing and does not display the correct time of day,
pressing the hour (H) or minute (M) button at any time will cause the clock to flash
again� You can now reprogram the correct time by following the previous steps�
NOTE: If you unplug the coee maker or in the event of a power loss, you will need to
reset the clock the next time the coee maker is plugged in�
Required for users in high-altitude areas� Not running the high-altitude calibration brew in
a high-altitude area will result in excessive steaming during brewing�
Because water boils at lower temperatures at higher altitudes, running a calibration cycle
before your first brew allows the unit to detect the boiling point of water at your location�
Running a calibration cycle will help deliver a consistent brew each time�
1 Fill the water reservoir up to, but not exceeding, the Max Fill line�
2 Place the empty filter holder into the brew basket, and an empty vessel in the machine�
3 Press and hold both CLASSIC and OVER ICE until clock displays CAL�
4 A calibration cycle will begin� When complete, the unit will beep and End will appear on
the clock display� Discard the water in the vessel�
NOTE: Pressing the CLASSIC, OVER ICE, or Power button will cancel the calibration cycle�
Remove all packaging material and stickers from the coee maker� Wash the water
reservoir, carafe, removable filter holder, and permanent filter (not included on all models)
in warm, soapy water with a soft cloth� Rinse parts and dry thoroughly� Before first use,
prime the system by running a Full Carafe, Classic brew cycle with water only� After the
cycle is complete, discard the water� For detailed instructions, refer to the Priming Your
Ninja Specialty Coee Maker section�
PLEASE KEEP THIS IMPORTANT SAFEGUARD IN MIND WHEN USING THE APPLIANCE:
DO NOT run the appliance without water�
NOTE: This calibration is permanently saved and will not be lost if power is lost or
brewer is unplugged� Brewer can be re-calibrated at any time if the altitude where it is
being used changes�
USING THE CONTROL PANEL PREPARING FOR USE
HIGH-ALTITUDE CALIBRATION BREW
SETTING THE CLOCK
1
3
5c
5
7
8
9
5a
5b
6a
6b
6c
2
4
5e
5d
5f
10
Loading ...
Loading ...
Loading ...