Loading ...
Loading ...
Loading ...
speed switch (1). The tool speed depends
on how far you depress the switch.
speed switch.
How to Use the Sightline
®
Feature
(gure H)
the line of cut can be easily followed.
H
11
HINTS FOR OPTIMUM USE
General
speed for aluminum and PVC and a low
speed for metals other then aluminum
blades (sold separately).
Sawing laminates
splintering may occur on the surface closest
to the shoe plate.
To minimize splintering, clamp a piece of
scrap wood or hardboard to both sides of the
Sawing metal
more time than sawing wood.
Use a saw blade suitable for sawing metal.
When cutting thin metal, clamp a piece
Spread a film of oil along the intended line
of cut.
Rip / Circle Cutting (Figure I - J)
Ripping and circle cutting without a pencil line
are easily done with
the rip fence / circle guide
Using the screw supplied with the accessory
guide, position
as shown in figure I and
thread the screw into the shoe to clamp the
fence securely.
When ripping, position as shown in figure I
and slide the rip fence under the screw from
either side of the saw. Set the
cross bar
at desired distance from blade and tighten
screw. For
ripping, the cross bar should be
down and against the straight edge of the
I
When circle cutting, adjust rip fence so that
distance from blade to hole in fence arm is at
the desired radius and tighten screws. Place
saw so that hole in fence arm is over center
of circle to be cut (drill hole for blade or cut
inward from edge of material to get blade into
position). When saw is properly positioned,
drive a small nail through hole in fence arm.
Using rip fence as a pivot arm, begin cutting
circle. For circle cutting, the cross bar should
be up, as shown in figure J.
J
Pocket Cutting (FIGURE K)
inside cut. The saw can be inserted directly
into a panel or board without first drilling a
shoe sits flate on the surface. Hold the shoe
flat against the wood and continue cutting.
moving. Blade must come to a complete stop.
K
Loading ...
Loading ...
Loading ...