Loading ...
Loading ...
Loading ...
10
Oil Fired Gas & Diesel • Rev. 4/7/2016
OPERATING INSTRUCTIONS
1. Perform pre-start maintenance inspection on all applicable systems prior to operating the
machine. This is essential for the safe, effective and efficient operation. You will get optimum
performance from your system ONLY if these instructions and inspections are followed. Any
indication that the pressure washing system was not operated and maintained according to these
instructions may cancel the manufacturers’ warranty.
Location – Be sure to install in an area that has sufficient air ventilation to support combustion
of oil in burner.
Controls – Make sure all controls turned to the off position.
Pump – Oil level - Level the pressure washer. Be sure oil level in the pump is correct on dip
stick. If the level is low, add the correct oil to the proper level. USE ONLY SAE 30 W NON-
DETERGENT OIL OR HYDRAULIC 68. DO NOT OVER FILL.
Gas Engine - Gasoline level – The engine is a 4 cycle and uses regular octane, unleaded fuel.
DO NOT USE MIXED FUEL. Refer to the engine operation manual included with your
pressure-washing unit.
Gas Engine - Oil level – The engine is a 4 cycle and uses 10W30 detergent oil. Refer to
Glossary or engine manual.
Diesel Engine – Refer to engine operation manual included with your pressure washing unit for
oil and fuel recommendations.
Oil Fired Burner - Oil Tank Level – #2 Furnace oil is recommended for the burner oil tank, as
it burns cleaner and the burner requires less maintenance. Diesel fuel may be used as an
alternative. Do not overfill burner tank.
Visually inspect all electrical components to assure they are in good condition, showing
No signs of exposure, breakage or splicing.
Visually inspect all hoses, nozzles and guns to assure they are in good condition. If
replacements are necessary they must be rated to withstand the machines operating
pressure and temperatures.
2. Attach high-pressure hose to hot water outlet quick connector. Attach the other end of high
pressure hose (with quick coupler) to spray gun. Ensure that quick disconnect connections are
tightly locked together. Apply a sharp pull on hose to confirm they are secured.
Attach wand nozzle specific to task requirements (i.e. chemical or pressure wash).
[Quick Coupling Operation – Pull back sleeve end and insert male end into nozzle quick coupler,
release sleeve and confirm connection by pulling on the nozzle].
Loading ...
Loading ...
Loading ...