Loading ...
Loading ...
Loading ...
Message Cause Action
Battery problem
Temporary battery or firmware related issue
in the product.
Restart the product. If the problem stays
speak to your authorized service technician.
Incorrect type of battery. Use original batteries recommended by the
manufacturer.
Battery temperature
outside limits
The temperature in the battery is too high or
too low to start operation.
No action. The product will start to operate
when the temperature is in limits.
Wrong PIN code
Wrong PIN code has been entered. Five at-
tempts are permitted, and the keypad is then
blocked for a period of time.
Enter the correct PIN code. Contact Husq-
varna customer service if you forget the PIN
code.
No drive
The product has got caught in something and
has been slipping.
Free the product and rectify the reason for
the lack of drive. If it is due to wet grass, wait
until the lawn has dried before using the
product.
The work area includes a steep slope. Steep slopes should be isolated. Refer to
To
put the boundary wire in a slope on page 16
.
The guide wire is not laid diagonally in the
slope.
Make sure that the guide wire is installed di-
agonally across the slope. Refer to
To make
a secondary area on page 18
.
Collision sensor
problem, front/rear
The product body can not move freely
around its chassis.
Check that the product body can move freely
around its chassis. If the problem stays
speak to your authorized service technician.
Alarm! Mower switch-
ed off
The alarm is activated because the product
had been switched off.
Adjust the security level in the
Security
menu. Refer to
To set the security level on
page 24
.
Alarm! Mower stop-
ped
The alarm is activated because the product
has been stopped.
Alarm! Mower lifted
The alarm is activated because the product
has been lifted.
Alarm! Mower tilted
The alarm is activated because the product
has been tilted.
Charging station
blocked
The contact between the charging plates on
the product on the and contact plates on the
charging station may be poor and the prod-
uct has made a number of attempts to
charge.
Put the product in the charging station and
check that the charging plates and contact
plates make good contact.
An object is in the way of the product that
prevents it to enter the charging station.
Remove the object.
The charging station is tilted or bent. Put the baseplate on level ground.
The guide wire is not installed correctly. Check if the guide wire is installed according
to the instructions. Refer to
To install the
guide wire on page 20
.
Stuck in charging sta-
tion
There is an object in the way of the product
preventing it from leaving the charging sta-
tion.
Remove the object.
Charging system
problem
Incorrect type of battery. Use original batteries recommended by the
manufacturer.
1440 - 004 - 24.03.2021 Troubleshooting - 39
Loading ...
Loading ...
Loading ...