Loading ...
Loading ...
Loading ...
manually to the selected area before you start the
Spot
cutting
operating mode.
Note: After the product has operated in the operating
mode
Spot cutting
, it will automatically start to cut in the
operating mode
Main area
or
Secondary area
.
4.3 To park the product
1. Push the STOP button to open the hatch.
2. Set the Main switch to position 0.
3. Enter the PIN code.
4. Push the PARK button.
5. Select an operating mode. Refer to
Operating
modes - Park on page 33
.
6. Push the OK button.
7. Close the hatch.
4.3.1 Operating modes - Park
•
Park until further notice
•
Start with schedule
4.3.1.1 Park until further notice
Use the operating mode
Park until further notice
for the
product to go back to the charging station. The product
will stay in the charging station until you select a new
operating mode.
4.3.1.2 Start again with next schedule
Use the operating mode
Start again with next schedule
for the product to go back to the charging station. The
product will stay in the charging station until the next
Schedule
setting.
4.4 To stop the product
1. Push the STOP button to make the product and
the cutting motor stop.
4.5 To switch off the product
1. Push the STOP button on top of the product.
2. Set the Main switch to position
0
.
4.6 To charge the battery
WARNING: Only charge the product
using a charging station which is intended
for it. Incorrect use may result in electric
shock, overheating or leakage of corrosive
liquid from the battery.
In the event of leakage of electrolyte flush
with water and seek medical help if it comes
in contact with the eyes etc.
When the product is new or has been stored for a long
period, the battery can be empty and needs to be
charged before starting. In the
Main area
mode, the
product automatically alternates between mowing and
charging.
1. Set the Main switch to position
1
.
2. Place the product in the charging station. Slide the
product in as far as possible to ensure proper
contact between the product and the charging
station. Refer to contact and charging plates in
Product overview Automower
®
310/315/315X on
page 4
3. The display shows a message that charging is in
progress.
4.7 Adjust the cutting height
CAUTION:
During the first weeks after
a new installation, the cutting height must be
set to MAX to avoid damaging the loop wire.
After this, the cutting height can be lowered
step by step every week until the desired
cutting height has been reached.
The cutting height can be varied from MIN (2 cm / 0.8
in.) to MAX (6 cm / 2.4 in.).
4.7.1 To adjust the cutting height
1. Push the STOP button to stop the product.
2. Open the hatch on the product.
1440 - 004 - 24.03.2021
Operation - 33
Loading ...
Loading ...
Loading ...