Loading ...
Loading ...
Loading ...
cablesshouldhaveminimalslack,butnottight.
Tightenorloosenhexnutson "Z"fittingstoadjust.
IMPORTANT:Iftherightlock-outcableisnotadjusted,
thewheelswilltendtoturn,Iftheleftlock-outcableis
notadjusted,theaugerswillkeeponrotating,
NOTE: The drive clutch cable is routed over the axle.
,_ WARNING" Do not over-tighten the clutch
cables. Tension on either cable in the
disengaged (up) position may override the
safety features of the machine.
NOTE: Two extra jam nuts are included in the hardware
pack (Group E) in the event either are lost during
shipping.
AttachingChuteAssembly(HardwareGroupF)
• Place chute assembly over chute opening, with the
opening in the chute assembly facing the front of
the unit.
• Place chute flange keepers beneath lip of chute
assembly, with the flat side of chute flange keeper
facing downward. See Figure 10.
• Insert hex bolt up through chute flange keeper and
chute assembly and secure with hex lock nut. After
assembling all three chute flange keepers, tighten
all nuts and bolts securely. Do not overtighten.
NOTE: Lock nuts cannot be threaded onto a bolt by
hand. Tighten with two 7/16" or adjustable wrenches.
Chute Assembly
,HexBolt
/
Hex Lock Nut
Chute Flange
Keeper
/
Figure 10
AttachingChuteDirectionalControl
(HardwareGroupG)
• Loosen the two hex nuts which secure the lower
chute directional control support bracket to the
snow thrower housing. See Figure 11.
• Insert the end of the chute directional control into
the hole in the plastic bushing on the chute bracket.
• Place the flat washer on the end of the chute
directional control, and secure with hairpin clip. See
Figure 11.
Hex Bolts &
Hex Lock Nuts
Lower
Chute
Directional
Control
Bracket
Plastic HexNuts
Bushing
Flat
Washer \ ChU;eoDirectional
1Clip
Chute Directional 1_'_
Control Bracket
Figure 11
Thread one hex nut onto the eyebolt on the chute
directional control assembly until there is at least
two inches of threads showing between the nut and
the eyebolt head. See Figure 12.
2" ofthreat
\
\
Hex Nut
Cupped
_Washer
Hex Nut
= Eye Bolt
Chute Directional
Control
Figure 12
Loading ...
Loading ...
Loading ...