Loading ...
Loading ...
Loading ...
AttachingClutchGrips(HardwareGroupB)
• Slide spacer on each end of the clutch grip and
place the clutch grip in position on the each
respective handle. Clutch grips must sit on top of
the handles. See Figure 6.
Hex Lock Nut
Hex Bolt
\
Spacer
Figure 6
Secure each clutch grip with a hex bolt threaded
from the outside of each handle and tighten with
hex lock nut under handle panel. See Figure 6.
AttachingHandlePanel(HardwareGroupC)
• Position the handle panel between handles and
insert two carriage bolts on each side and secure
with lock washers and hex patch nuts.
See Figure 7.
Hex Cap
Carriage Bolts
Hex Lock Nuts
Bolts
Figure 7
Self-Tapping
Screws
AttachingSpeedSelectorPlateAnd
ShiftLever(HardwareGroupD)
• Assemble the speed selector plate to the outside
of the handles. Secure using two self-tapping
screws on each side. See Figure 8.
• Insert the shift lever through slot inthe speed
selector plate. See Figure 8.
Self-Tapping
Screws
Speed Selector
Self-Tapping
.Screws
_Hex Lock Nuts
Bolts _Shift Lever
Spring
Figure 8
NOTE: The bend in the lever should be towards the
operator.
• Secure shift lever to the shift lever spring using two
hex bolts and hex lock nuts. Tighten both bolts
finger tight. At this point the shift lever and shift
lever spring are not against each other. As you
tighten the bolts and nuts with two wrenches, these
will pull together.
• Tighten all hardware assembled to this point. Make
sure that clutch grips are moving freely.
AttachingControlCables(HardwareGroupE)
• Take a "Z" fitting from the hardware pack and insert
the Z end into the hole on the left clutch grip on the
handle panel. See Figure 9. Thread a hex nut from
hardware pack on to the Z fitting.
_ Clutch Grip
_e //"_"Z" Fitting
[.._neJ _ Hex Nut
Figure 9
• Route the left cable between engine and speed
selector plate and then between handle panel and
clutch lever pivot rod. Make sure the cable is routed
correctly in the cable roller guides located at the
lower rear of the unit.
• Thread cable onto the left "Z" fitting.
• Assemble the right "Z" fitting on the right clutch grip
and attach the right cable in the same manner. Both
Loading ...
Loading ...
Loading ...