Loading ...
Loading ...
Loading ...
10
ELECTRICAL CONNECTION
For personal safety, the appliance must be properly grounded.
Remove house fuse or open circuit breaker before beginning installation.
Do not attempt to repair or replace any part of the appliance unless it is specifically recommended in
this manual. All other servicing should be referred to a qualified technician.
To minimize the possibility of electric shock, disconnect this appliance from the A/C power supply before
attempting any maintenance.
Before installing this appliance, please check the rating on the rating label located on the rear cover of
this appliance. The unit must be connected to the proper electrical voltage and frequency as specified
on the rating label.
Do not use an extension cord.
NOTE: Turning the appliance off does not disconnect the appliance from the power supply. We recommend
having a qualified technician service your appliance.
MODELS: CSD2B115 / CSD2B115E / LCSD1152B
This appliance should be properly grounded for your safety. The power cord of the appliance is
equipped with a grounded plug that mates with standard three prong wall outlets to minimize the
possibility of electrical shock.
Do not under any circumstances cut or remove the third ground prong from the power cord supplied.
For personal safety, this appliance must be properly grounded.
This appliance requires a standard 115/120 Volt AC ~/60Hz electrical ground outlet with three-prong
socket. Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is
properly grounded. When a standard 2-prong wall outlet is encountered, it is your responsibility and
obligation to have it replaced with a properly grounded 3-prong wall outlet.
The appliance should always be plugged into its own individual electrical outlet that has a voltage rating
that matches the rating label on the appliance. This provides the best performance and also prevents
overloading house wiring circuits that could cause a fire hazard from overheating. Never unplug the
appliance by pulling the power cord. Always grip the plug firmly and pull straight out from the receptacle.
Repair or replace immediately all power cords that have become frayed or otherwise damaged. Do not
use a cord that shows cracks or abrasion damage along its length or at either end. When moving the
appliance, be careful not to damage the power cord.
MODELS: CSD2B230 / CSD4B24 / CSD4B300 / CSD4B301E / LCSD302
The appliance must be properly installed and grounded by a qualified technician in accordance with
the National Electrical Code ANSI/NFPA No. 70 (Latest Edition) and local electrical code requirements.
Installation should be made by a licensed electrician.
The unit may be connected by means of permanent Hard Wiring or Power Supply Cord Kit. The power
supply cord is not supplied but is available through your local electrical supplies supplier.
Use only a 3-conductor or 4-conductor UL-listed cord rated at 20 amps with a 250V minimum voltage
range. These cords may be provided with strain relief or a conduit connector.
The unit should be connected directly to the junction box through flexible, armored or nonmetallic
sheathed, copper cable. The flexible, armored cable extending from the fuse box or circuit breaker box
should be connected directly to the junction box. Locate the junction box to allow as much slack as
WARNING
Improper connection of the equipment-grounding can result in the risk of electrical shock. If the
power cord of the unit is damaged, have it replaced by an authorized service center.
Loading ...
Loading ...
Loading ...