Loading ...
Loading ...
Loading ...
BLADERUNNER
®
X2 ENG
14
TROUBLESHOOTING
Symptom Possible Causes Possible Solution
Tool will not start when
switched on.
• Power cord is not plugged
in.
• Check to make sure power cord is connected
well into a working outlet.
Poor cut quality
• Blade is worn out.
• Blade is set incorrectly
• Too much vibration in
material.
• Too much vibration of the
saw.
• Feed rate too fast.
• Make sure the blade is sharp and not broken.
• Make sure the blade is installed properly.
• Tighten Guard and Guard Arm firmly down
onto material.
• Clamp or fasten saw base to tabletop.
• Feed the material more slowly.
Work efficiency is low.
• Blade is worn out.
• Feed rate too fast.
• Change to a new blade.
• Feed the material more slowly.
Blade is not clamped tightly by
the Blade Holder.
• Blade is not inserted into
place fully.
• Use blade grip to push the blade as far into
the blade holder as possible before letting go of
Blade Release.
Blade Release button cannot
be pressed down.
• Dust accumulates.
• Clean the dust around the Blade Release
button.
Guard Arm vibrates too much.
• Screws fixing the Guard
Arm on the work table are
loose.
• Tighten the screws as shown in Fig A1.
Rip Fence cannot slide into
Fence Slot smoothly.
• Rip Fence locking knob too
tight.
• Loosen the Rip Fence locking knob.
Loading ...
Loading ...
Loading ...