Loading ...
Loading ...
Loading ...
11
BLADERUNNER
®
X2 ENG
or dust mask if cutting operation is dusty. Everyday
eyeglasses only have impact resistant lenses, they
are NOT safety glasses.
12. SECURE WORK. Use clamps or a vise to hold work
when practical. It’s safer than using your hand and it
frees both hands to operate tool.
13. DON’T OVERREACH. Keep proper footing and
balance at all times.
14. MAINTAIN TOOLS WITH CARE. Keep tools
sharp and clean for best and safest performance.
Follow instructions for lubricating and changing
accessories.
15. DISCONNECT TOOLS before servicing; when
changing accessories, such as blades, bits, cutters,
and the like.
16. REDUCE THE RISK OF UNINTENTIONAL
STARTING. Make sure switch is in off position
before plugging in.
17. USE RECOMMENDED ACCESSORIES. Consult the
owner’s manual for recommended accessories. The
use of improper accessories may cause risk of injury
to persons.
18. NEVER STAND ON TOOL. Serious injury could
occur if the tool is tipped or if the cutting tool is
unintentionally contacted.
19. CHECK DAMAGED PARTS. Before further use
of the tool, a guard or other part that is damaged
should be carefully checked to determine that it will
operate properly and perform its intended function
– check for alignment of moving parts, binding of
moving parts, breakage of parts, mounting, and
any other conditions that may affect its operation.
A guard or other part that is damaged should be
properly repaired or replaced.
20. DIRECTION OF FEED. Feed work into a blade or
cutter against the direction of rotation of the blade
or cutter only.
21. NEVER LEAVE TOOL RUNNING UNATTENDED.
TURN POWER OFF. Don’t leave tool until it comes to
a complete stop.
Figure 1
Grounding methods
Metal screw
Grounding pin
Grounding pin
Adapter
Grouding
means
Cover of grouded
outlet box
(A) (B)
(C) (D)
Table 1
Minimum gage for cord
Ampere
Rating
Volts Total length of cord in feet
120V 25ft 50ft 100ft 150ft
More
Than
Not More
Than
AWG
0
6
10
12
6
10
12
16
18
18
16
14
16
16
16
12
16
14
14
14
12
12
Not
Recommended
ADDITIONAL SAFETY WARNING
FOR ALL SAWS
DANGER: Coasting Cutting Tool Can Be
Dangerous – Apply brake immediately to
stop cutting tool when the switch is turned off.
WARNING: The torque developed during
braking may loosen the blade-retaining nut,
and the nut should be checked periodically and
tightened if necessary, especially after braking.
Loading ...
Loading ...
Loading ...