Loading ...
Loading ...
Loading ...
-5-
Additional Safety Warnings
Some dust created by
power sanding, sawing,
grinding, drilling, and other construction
activities contains chemicals known to
cause cancer, birth defects or other
reproductive harm. Some examples of
these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement
and other masonry products, and
• Arsenic and chromium from chemically-
treated lumber.
Your risk from these exposures varies,
depending on how often you do this type
of work. To reduce your exposure to
these chemicals: work in a well ventilated
area, and work with approved safety
equipment, such as those dust masks
that are specially designed to filter out
microscopic particles.
Charger Safety Rules
a. This manual contains instructions for
battery charger model 510. Do not
substitute any other charger.
b. Before using battery charger, read all
instructions and cautionary markings on
(1) battery charger, and (2) product
using battery.
c. Charge only Dremel HSES-01. Other
types of cordless tools may burst causing
personal injury and damage.
d. Charge tool in temperatures above +41
degrees F (5 degrees C) and below +113
degrees F (45 degrees C). Store tool in
locations where temperatures will not
exceed 120 degrees F (49 degrees C).
This is important to prevent serious
damage to the battery cells.
e. Do not recharge tool in damp or wet
environment. Do not expose charger to
rain or snow. Water entering battery
charger may result in electric shock or
fire.
f. Battery leakage may occur under
extreme usage or temperature
conditions. Avoid contact with skin and
eyes. The battery liquid is caustic and
could cause chemical burns to tissues. If
liquid comes in contact with skin, wash
quickly with soap and water. If the liquid
contacts your eyes, flush them with water
for a minimum of 10 minutes and seek
medical attention.
g. Place charger on flat nonflammable
surfaces and away from flammable
materials when recharging tool.
Carpeting and other heat insulating
surfaces block proper air circulation,
which may cause overheating of the
charger and tool. If smoke or melting of
the charger or tool is observed, unplug
the charger immediately and do not use
the tool or charger. Contact customer
service immediately.
h. Make sure cord is located so that it will
not be stepped on, tripped over, or
otherwise subjected to damage or
stress. Damaged plug and cord may
result in electric shock or fire.
i. Disconnect the charger by pulling the
plug rather than the cord. Do not
operate charger with damaged cord or
plug; have them replaced immediately.
Damaged plug or cord may result in
electric shock or fire.
j. Do not disassemble charger or operate
the charger if it has received a sharp
blow, been dropped or otherwise
damaged in anyway. Incorrect
reassembly or damage may result in
electric shock or fire.
k. Before each use, check the battery
charger, cable and plug. If damage is
detected, do not use the battery
charger. Never open the battery charger
yourself, take it to a Dremel Factory
Service Center, or qualified serviceman
only using original spare parts. Incorrect
reassembly may result in electric shock or
fire.
l. Do not use attachments not
recommended or sold by Dremel. Using
attachments not recommended may
result in electric shock or fire.
m. Unplug tool from charger when battery
in tool is fully charged. Tool left plugged
in the charger over a long period of time
could lead to tool damage and fire.
n. Unplug charger from outlet before
storage, attempting any maintenance or
cleaning. Such preventive safety
measures reduce the risk of electric
shock or fire.
Loading ...
Loading ...
Loading ...