Loading ...
Loading ...
Loading ...
• Tuner
Problem Cause Remedy Refer to
page
FM stereo reception is 13
noisy.
FM
There is distortion, and
clear reception cannot
be obtained even with a
good FM antenna.
The desired station
cannot be tuned in with
the automatic tuning
method.
Tile characteristics of FM stereo
broadcasts may cause this problem
when the transmitter is too far away or
tile anlenna input is poor.
The desired station
cannot be tuned in with
the automatic tuning
method.
Check the antenna conn_tions.
Try using a high-quality directional FM
antenna.
Use tile manual tuning me_hod. 32
There is multipath interference. Adjust the antenna position _o eliminate
multipath inteffelence.
The station is loo weak.
Use a high-quality dilectional FM antenna.
Use tile manual luning me_hod.
32
Previously preset The unit has been disconnected for a Re-store file stations. 33
stations can no longer king period.
be tuned in.
The signal is weak or the antenna Tighten theAM loop antenna connections and
connections are loose, orien[ it for best reception.
Use tile manual tuning me_hod. 32
There are continuous Noises result from lightning, Use an outdoor antenna and a grotlnd wire. 13
AM crackling and hissing fluorescent lamps, ixtOtOlS, thel_noslals This will help somewhal, bu_ it is diMcuk _o
noises, and other electrical equipment, eliminate all noise.
There are bulling and A TV set is being used nearby. Move this unit away from the TV.
whining noises
(especially in the
evening).
• Remote control
Problem Cause Remedy Refer to
page
The remol_ control does Wrong distance or angle. The remote control will tunction within a 7
not work nor function maximum range of 6 m (20 fee0 and no more
properly, than 30 degrees of!_axis from the front panel.
Direct sunlight or lighting (from an Reposition this unit.
inverter type of fklorescent lamp, etc.) is
s_riking the remote control sensor of this
unit.
The batteries ale weak.
The manufacture code has nor correctly
s_t.
Even if the manufacturer code is correctly
set, there ale some models that do not
respond to the remote controL
Replace all batteries with new ones.
Set the code correctly.
Try setting another code of the same manufac-
turel_
3
46
46
54
Loading ...
Loading ...
Loading ...