Loading ...
Loading ...
Loading ...
9
TROUBLESHOOTING
Check the following points before calling your local Customer Service Center.
PROBLEMS CAUSE SOLUTION
The appliance is operating in
dehumidifying mode, but the
humidity does not decrease.
The lters are blocked. Clean the lters.
The temperature or humidity in the
room are too low.
In certain conditions, it is normal for
the appliance not to dehumidify (in
certain cases, it is recommended to
heat the environment).
Too many sources of humidity in the
room (pots of boiling water, etc.).
Eliminate as many sources of humidi-
ty as possible.
The humidy set point is too high. Decrease the humidity set point.
The appliance does not work for 3
minutes after start-up.
The safety device has tripped. Wait for 3 minutes to pass.
is displayed
The tank is missing.
Replace the tank.
The tank is full. Empty the tank.
The tank is incorrectly positioned. Position the tank correctly.
is displayed
The temperature in the room is very
low.
Increase room temperature.
“E2”/”E3” is displayed
One of the sensors on the appliance
is faulty.
Call the Customer Service Center.
“PUMP” symbol blinking The pump tube (9) is missing or
clogged or blocked.
Check the hose is correctly positioned
or unclogged, To reset the alarm
disconnect and reconnect the plug.
If the problem persists, call the Cus-
tomer Service Center.
Loading ...
Loading ...
Loading ...