Loading ...
Loading ...
Loading ...
6
CONTROL PANEL
ON/STANDBY
Room
temperature
button °F/°C
Fan speed
button
Display Decrease
humidity level
button
TIMER
button
Increase
humidity level
button
PUMP
button *
* (only on some models)
Description of buttons
1 ON/Standby” button
ON/Standby” button
2 “Fan” button
Press this button to select the Fan Speed (MIN or MAX).
3 Thermometer button
Temporarily displays the temperature measured in the room by
the appliance. If you press the button once you will see the room
temperature in F for a few seconds, then in C for a few seconds,
then the display will return to the current level of humidity in
the room. If you press the button multiple times, it will cycle
through these displays faster.
Note: Temperatures displayed are indicative only.
4 Humidity increase/decrease buttons
These buttons are used to adjust the desired humidity level,
with 5% increments; they are also used to set the timer. From
0 -10 the hours increase by 30 min. and from 10-24 the hours
increase by 1 hour increments.
5 Pump button
(only in some models)
When you press the “Pump button” the display will show
“PUMP/POMPE”. If the display shows “PUMP/POMPE” blinking,
it means that the pump is not operating correctly.
6 Timer button
If you press the TIMER button the display will show the hours
after which you want the appliance to switch OFF or ON. Once
the timer is set the user can no longer adjust the %RH (Relative
Humidity)
Display
Meaning of the codes or symbols which may be displayed:
-- --
Indicates that the appliance is in standby mode.
Tank warning symbol
If the water tank is full, improperly positioned or missing, the
tank warning light will start blinking.
An alarm will sound until the tank is either emptied or correctly
positioned into place.
Defrosting indicator symbol
With an ambient temperature of less than 59°F (15°C) the appli-
ance performs defrosting cycles.
While the appliance is defrosting, the defrosting symbol comes
on and remains on until defrosting is completed. This symbol
will also be displayed if the unit is switched on immediately
after being turned o. The unit requires 3 minutes before it can
function again.
Loading ...
Loading ...
Loading ...