Loading ...
Loading ...
Loading ...
6
Liner Installation
6. The custom hood frame must have a sturdy
base to accommodate the cut-out for the insert.
The base must be recessed to accommodate
the height of the liner (See liner dimension on
Page 13).
7. Secure the liner to the bottom of the base using
screws (not included) appropriate for the size
and material of your wood frame.
8. Position the liner so that it aligns with the back
edge of the custom wood frame. Use a pen to
trace the outline of the pre-cut area. Remove
the liner and proceed to Hood Preparation
before Installation on Page 6.
9. Install the liner with 5 screws (not provided).
Wiring to Power Supply
SAFETY WARNING
RISK OF ELECTRICAL SHOCK. THIS RANGE
HOOD MUST BE PROPERLY GROUNDED.
MAKE SURE THIS IS DONE BY QUALIFIED
ELECTRICIAN IN ACCORDANCE WITH ALL
APPLICABLE NATIONAL AND LOCAL
ELECTRICAL CODES. BEFORE CONNECTING
WIRES, SWITCH POWER OFF AT SERVICE
PANEL AND LOCK SERVICE PANEL TO
PREVENT POWER FROM BEING SWITCHED ON
ACCIDENTALLY.
10. Temporarily wire the hood to test for proper
operation before installing. If the insert does not
operate, check the circuit breaker or house fuse.
If the insert is still not working, disconnect the
power supply and check the continuity of all
wiring connections.
11. Connect electrical wires.
12. Connect three wires (black, white and green) to
house wires and cap with wire connectors.
Connect wires according to their colors (i.e.
black to black, white to white, and green to
green).
13. Store wires in the wiring box. See Figure 4.
NOTE: Connect all electrical wires before installing
insert. DO NOT turn on the power until installation
is complete.
Figure 4
Figure 5
Figure 6
Loading ...
Loading ...
Loading ...