Loading ...
Loading ...
Loading ...
Washing your filters
Washing filter A
For more information and support videos for your machine go online:
www.dyson.com/support
Wash your filters at least once a month to maintain optimum suction power.
Remove your filter
Reassemble your filter
Dry your filter
Wash your filter
Press the button on the bin handle to detach the bin from your machine.
Drop your filter back into your machine. Close the handle and make sure it
clips into place.
Place the base of your bin onto your machine and then push the top into
position until it clicks.
Squeeze the excess water out of your filter.
Leave your filter to dry for at least 24 hours in a well-ventilated, warm place.
Don’t dry your filter in a tumble dryer, microwave or near a naked flame.
Important: your filter must be completely dry before you put it back into the
machine. Your machine could be damaged if used with a damp filter.
Push up the catch on the front of the bin handle and lift out the filter.
Only wash the filter with cold water. Hold the open end of the filter under
a running tap, until the water runs clear.
Turn the filter upside down and tap to remove excess water.
Run water over the outside of the filter until the water runs clear.
Squeeze and twist with both hands to make sure the excess water is removed.
clik
The clip to open the top of
the cyclone can be found
where the bin handle joins
the cyclone.
With the handle
lifted up, the
filter can be
located in the
center of the
cyclone unit.
The filter should be dropped
back into the center of the
cyclone unit and the handle
pushed down into position with
a click.
Remove the
plug from the
power source.
Loading ...
Loading ...