Loading ...
Loading ...
Loading ...
ENGLISH
6
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can causeinjury.
Fig.I
17
2
Proper Hand Position (Fig. J)
WARNING: To reduce the risk of serious personal
injury, ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
suddenreaction.
Proper hand position requires one hand on the spray handle
grip
4
and the other hand on the spray handle
3
.
Test Ground-Fault Circuit-Interrupter
(GFCI) Before Each Use (FIg. A)
This pressure washer is provided with a ground-fault circuit-
interrupter (GFCI) built into the plug of the power-supply
cord. This device provides additional protection from the
risk of electricshock.
1. Plug the Ground Fault Circuit Interrupter (GFCI)
13
into
a working grounded outlet.
2. The indicator at the top of the GFCI should turn green
when product is ready to use.
3. Press the “TEST” button (bottom). The green indicator
should disappear.
4. Press “RESET” button for use. Do not use if the above
test fails.
Fig.J
3 4
Pressure Washing
Preparing Surface for Cleaning
• Remove objects from the area which could create a
hazard such as children's toys or outdoor furniture.
• Ensure that all doors and windows are closed tight. Protect
all plants and trees in the adjacent area with a drop cloth
ensuring that they will not be harmed by any overspray.
• Pre-rinse cleaning area with fresh water.
• Use only detergents formulated for pressure washers.
• Always test detergent in an inconspicuous area before use.
Preparing Pressure Washer Unit for Use
(Fig. A)
DANGER: Risk of fluid injection and laceration.
When using the high-pressure setting, DO NOT allow
the high-pressure spray to come in contact with
unprotected skin, eyes, or with any pets or animals.
Serious injury willoccur.
CAUTION: Before operation:
- Connect the water supply to the pressure washer . For
instructions on connecting the water supply to the
pressure washer, please refer to Attaching Garden
Hose under Assembly andAdjustments.
- Connect the high pressure hose to the pressure washer
and the pressure wand. For instructions on connecting
the high pressure hose to the pressure washer and
pressure wand, please refer to Attaching High
Pressure Hose under Assembly andAdjustments.
Preparing Spray Handle (Fig. K)
IMPORTANT: Before turning on the pressure washer unit,
disengage the trigger lock-off
5
and squeeze the trigger
6
.
Hold the trigger for 30 seconds to purge the system of air. If
air is still found in the water stream, continue to run water
through the sprayhandle.
1. Disengage the trigger lock-off
5
.
2. Squeeze the trigger
6
.
Fig.K
4
6
5
Cleaning a Surface (Fig. A, L)
• To start the pressure washer, rotate the ON/OFF switch
8
to the ON position..
• The best angle for spraying water against a cleaning
surface is 45°. Spraying head on tends to cause dirt
particles to embed in the surface. When working on
vertical surfaces, it is best to apply detergent starting at
WARNING:
Risk of bursting. Use a tire pressure gauge to
check the tires pressure before each use and while inflating
tires; see the tire sidewall for the correct tire pressure.
NOTE: Air tanks, compressors and similar equipment
used to inflate tires can fill small tires similar to these
very rapidly. Adjust pressure regulator on air supply to
no more than the rating of the tire pressure. Add air in
small increments and frequently use the tire gauge to
prevent over inflation.
Loading ...
Loading ...
Loading ...