Loading ...
Loading ...
Loading ...
ENGLISH
4
The label on your tool may include the following symbols. The
symbols and their definitions are asfollows:
V ......................... volts
Hz .......................hertz
min ..................... minutes
or DC ......direct current
...................... Class I Construction
(grounded)
…/min ..............per minute
BPM .................... beats per minute
IPM ..................... impacts per minute
RPM .................... revolutions per
minute
sfpm ................... surface feet per
minute
SPM .................... strokes per minute
OPM .................... oscillations per
minute
A ......................... amperes
W ........................watts
or AC ...........alternating current
or AC/DC .... alternating or
direct current
...................... Class II
Construction
(double insulated)
n
o
.......................no load speed
n .........................rated speed
......................earthing terminal
.....................safety alert symbol
.....................visible radiation
..................... avoid staring at
light
..................... wear respiratory
protection
..................... wear eye
protection
..................... wear hearing
protection
..................... read all
documentation
IPXX .................... IP symbol
High Pressure Hose Storage (Fig. D)
1. To store the high pressure hose
1
neatly coil the hose
and secure it with the attached strap as shown in Fig. D.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can causeinjury.
Intended Use
This pressure washer is intended for cleaning boats, cars,
decks, driveways, grills, house siding, motorcycles, patios,
and outdoorfurniture.
DO NOT use under wet conditions or in presence of flammable
liquids orgases.
DO NOT let children come into contact with the tool. Supervision
is required when inexperienced operators use thistool.
Motor
Be sure your power supply agrees with the nameplate
marking. Voltage decrease of more than 10% will cause loss
of power and overheating. These tools are factory tested; if
this tool does not operate, check power supply.
Assemble Frame Handle (Fig. A–C)
Your pressure washer is not fully assembled in the carton.
1. To assemble the frame handle
9
to the pressure washer
unit
7
, line the upper poles
15
with the lower poles
16
so the detent pins snap intoposition.
Fig.B
15
16
Fig.C
9
7
Specifications
Maximum Pounds per Square Inch 2,400
Rated Gallons per Minute* 1.1
Electrical Requirements 120V
AC
~60Hz, 13A
Electrical Cord 35 ft. (10.6 m)
High Pressure Hose 25 ft. (7.6 m)
Minimum Amp Source 15A
Pressure of Inlet Water* 20-100 PSI
Inlet Water Cold Tap
Soap Consumption Rate 10% MAX
*Water flow and maximum pressure ratings determined in accordance with CETA CPC-100.
Fig.D
1
Loading ...
Loading ...
Loading ...