Loading ...
Loading ...
Loading ...
EN - 24
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
Motor will not start.
On/Off switch is
in the “OFF” (O)
position.
Turn switch to the “ON” ( | ) position. Squeeze gun
trigger.
Power cord is not
plugged in.
Plug in power cord.
Extension cord is
too long.
Extension cord is
not proper gauge.
Extension cord is
damaged.
Replace extension cord with either a 25’ (7.6 m)
14 AWG cord or a 50’ (15 m) 12 AWG cord.
Electrical outlet
does not supply
adequate power.
Try a different outlet.
Tripped pressure
washer circuit
breaker.
Allow to cool, and restart unit.
Unit does not reach
high pressure.
Diameter of garden
hose is too small.
Replace with a 1” (25 mm) or 5/8” (16 mm) garden
hose.
Water supply is
restricted.
Check garden hose for kinks, leaks and blockage.
Not enough water
supply.
Open water source fully.
Pressure tip has not
been installed on
wand assembly.
Add desired pressure tip to end of wand. See page
19 Fig. 10 for details.
Water intake filter is
clogged.
Remove lter and rinse in warm water.
Pump is sucking air.
Check that hoses and ttings are airtight. Turn
"OFF" machine, and purge pump by squeezing
trigger gun until a steady ow of water emerge
through the spray tip.
Detergent bottle
or suction tube not
properly connected.
Install detergent bottle or suction tube correctly.
Detergent is too
thick.
Dilute detergent.
Loading ...
Loading ...
Loading ...