Loading ...
Loading ...
Loading ...
2) Pour 1-4 teaspoons cleaning agent into tank depending on the amount of scale.
3) Insert the main power wire, leave lid off unit and start up a cycle by pushing “Reset button”.
4) Let cycle run for 30 minutes, unplug the power line, pour out water and wash the inside of
tank with clean water.
5) If scale is not completely removed, please repeat the process.
NOTE:Don’t use the corrosive cleaning agent or hard brush to avoid damaging the surface
of the stainless-steel liner. Use the soft cloth to wipe the stainless-steel tank after cleaning.
6) Using dry cloth to wipe the plug on the two ends after cleaning. This can prevent water
seepage of the socket, thus causing electric leakage.
[ 7 ]
Trouble Shooting
1. No distilled water comes out
1) Main power wire and power wire of the top cover disconnected.
2) Out of power for electric outlet.
3) Reset button is not pressed
(indication light is not on).
4) No water filled with stainless tank.
2. Not enough volume of distilled
water after cycle finished
1) Water was not fill to the highest
water level line.
2) The sealing rubber ring of top cover
fails to work, need to be changed.
3) The sealing rubber ring is squeezed
by the filter, the filter needs to be set up properly.
4) The filter does not align to the water bottle properly.
3. The sealing area between top cover and machine body is jittering
1) Top cover and machine body does not close tightly.
2) Too much drain retained in the filter, filter needs to be changed.
Cleaning
1. Rinse and wipe out tank everyday using clean water and keep it dry.
2. The stainless-steel liner must be rinsed and cleaned with water. Calcification and scale will build
up on bottom of the tank and should be removed every month by using specific cleaning
agent.
Please follow the below instructions:
1) Pour in enough hot water to cover scale in the tank.