Loading ...
Loading ...
Loading ...
1. The reset button is just for starting the machine, It is not for operation. The machine will
auto-switch-off when finished.
2. The reset button of the water distiller has been set to be “start” after leaving the factory, so you
don't need to press it to start the machine for the first time.The user just needs to plug the top
cover and main power line for an automatic start.
3. Reset button will begin a new distilling cycle until the last
cycle is over. And the unit will automatically turn itself off
when every cycle is finished.
[ 5 ]
1. Unpack the box and take out the water distiller.
There are two parts to it; Top Cover and Machine
Body. Lift the Top Cover up and take out the Water
Bottle.
NOTE: Do not remove the cover while the unit is
mid-cycle. After power off, the internal temperature of
the machine is still very high. It must be cooled down
for at least 20 minutes after distilled process finished,
then remove the top cover to avoid scalding injuries.
Reset Button & Switch
Set Up
2. Lift the Top Cover up and fill the stainless-steed
3. Place top cover on the machine body, check
carefully if the top cover is correctly sealed
and adjust the position from left-right
control, and make sure the silicon seal is
correctly in place around the entire rim.
Check to make sure the unit is on a stable
surface.Then plug the power wire of the top
cover into the machine’s body.
Power port & fan condenser port
Switch
Food -grade 304 stainless steel interior
4.This is the water purification switch. It turns the device on
and off. If you wish to pause the device simply switch it off.
This allows the device for run for extended periods.
tank with water up to the maximum water level line.
Please pay attention not to exceed the FULL
water level line (Time of water distillation can be
reduced if filling with hot water) .
Shockproof glass water container
Loading ...
Loading ...