Loading ...
Loading ...
Loading ...
Rinnai 15 EHPA_VMA Series 2 Heat Pump OIM
REGULATIONS AND OCCUPATION HEALTH AND SAFETY
(
OH&S
)
WARNING
Installation and commissioning MUST be performed by authorised persons�
The heat pump MUST be installed in accordance with these instructions and all regulatory
requirements which exist in your area including those in relation to manual lifting�
Applicable publications and regulations may include:
•
AS/NZS 3500 National Plumbing and Drainage
•
AS/NZS 3000 Wiring Rules
•
Building Codes of Australia (BCA)
•
Local Occupational Health and Safety (OH&S) regulations
This appliance is not suitable for use as a domestic spa pool or swimming pool heater�
Electric Heat pumps are heavy and bulky items� Australian States and Territories have a Principal
Occupational Health and Safety (OH&S) Act which contains requirements relating to the handling
of large, bulky or awkward items� Persons installing heat pump systems MUST be aware of
their responsibilities and be adequately trained and qualied, in accordance with local OH&S
requirements�
LOCATION
The electric heat pump can be installed externally or internally.
The electric heat pump should be placed as close as practicable to the most frequently used hot water outlet point
or points to minimize the delay time for hot water delivery. This will usually be the kitchen tap. For installations
where the distance between the heat pump and the outlets is considerable, a ow and return system can be used
which minimize the waiting time for hot water delivery.
It is recommended that all components are installed at ground or oor level. The heat pump MUST be installed in
a vertically upright position. All components MUST be accessible without the use of a ladder or scaffold. The unit
MUST NOT be installed in roof spaces.
WARNING
As the heat pump contains a ammable refrigerant, ensure the installation location complies with
the requirements of AS/NZS 60335�2�40 & AS / NZS 5149�
The air inlet and outlet of the heat pump module MUST be away from areas with strong wind and MUST be
provided with sufcient clearances as per those shown in the section ‘’ on page 13.
The heat pump MUST be connected to an independent AC 240 V, 50 Hz power supply.
Ensure the pressure and temperature pressure relief (PTR) valve and any access covers have sufcient clearances
and are accessible for service and removal. The information on the rating plates MUST also be readable.
The heat pump MUST be installed free-standing on a level and stable base. The cylinder should be mounted on a
concrete base at least 50mm thick or on well-seasoned, evenly spread hardwood slats with a thickness of at least
25mm. Where property damage can occur as a result of water leakage, the storage cylinder MUST be installed
with a safe tray (overow tray) and drain in accordance with AS 3500.4. Ensure the storage cylinder DOES NOT
stand on wet surfaces.
The air inlet and outlet of the heat pump module MUST be away from areas with strong wind and MUST be
provided with sufcient clearances as per those shown in section “Clearances” on page 14.
The heat pump MUST be connected to an independent AC 240 V, 50 Hz power supply.
Internal Installation
For internal installations the area MUST meet the following requirements:
•
Minimum room volume of 39m
3
per unit.
•
Good Ventilation (i.e minimum 200 L/s per unit)
•
Away from any ignition sources or corrosive environments.
If the heat pump is installed internally careful consideration should be taken in regards to positioning and limiting
the effect of unit noise and reverberation during operation.
INSTALLATION
Loading ...
Loading ...
Loading ...