Loading ...
Loading ...
Loading ...
Bevel
Angle
Setting
33.85 _
33.85 _
33.85 _
33.85
Type of Cut
Left side, inside corner
1. Top edge of molding against fence
2. Miter table set right 31.62
3. Save left end of cut
Right side, inside corner
1. Bottom edge of molding against fence
2. Miter table set left 31.62
3. Save left end of cut
Left side, outside corner
1. Bottom edge of molding against fence
2. Miter table set left 31.62
3. Save right end of cut
Right side, outside corner
1. Top edge of molding against fence
2. Miter table set right 31.62
3. Save right end of cut
CUTTING WARPED MATERIAL
See Figures 32 and 33.
When cutting warped material, always make sure it is
positioned on the miter table with the convex side against the
fence as shown in figure 32.
Ifthe warped material is positioned the wrong way as shown
in figure 33, it will pinch the blade near the completion of the
cut.
Fig. 33
WARNING:
To avoid a kickback and to avoid serious personal injury,
never position the concave edge of bowed or warped
material against the fence.
i
CLAMPING WIDE WORKPIECES
See Figure 34.
When cutting wide workpieces, such as 51 mm x 152 mm
(52 in. x 6 in.), boards should be clamped with a C-clamp as
shown in figure 34.
RIGHT
Fig. 32
Page 25
Loading ...
Loading ...
Loading ...