Loading ...
Loading ...
Loading ...
CUTTING CROWN MOLDING
Your compound miter saw does an excellent job of cutting
crown molding. Ingeneral, compound miter saws do a better
job of cutting crown molding than any other tool made.
In order to fit properly, crown molding must be compound
mitered with extreme accuracy.
The two contact surfaces on a piece of crown molding that
fit flat against the ceiling and the wall of a room are at angles
that, when added together, equal exactly 90. Most crown
molding has a top rear angle (the section that fits flat against
the ceiling) of 52 and a bottom rear angle (the section that
fits flat against the wall) of 38.
LAYING MOLDING FLAT ON THE MITER TABLE
See Figure 31.
To use this method for accurately cutting crown molding for
a 90 inside or outside corner, lay the molding with its broad
back surface flat on the miter table and against the fence,
52°
W
A
L
L
When setting the bevel and miter angles for compound
miters, remember that the settings are interdependent; chang-
ing one angle changes the other angle as well.
Keep in mind that the angles for crown moldings are very
precise and difficult to set. Since it is very easy for these
angles to shift, all settings should first be tested on scrap
molding. Also most walls do not have angles of exactly 90 _,
therefore, you will need to fine tune your settings,
When cutting crown molding by this method the bevel angle
should be set at 33,85 _.The miter angle should be set at
31,62 either right or left, depending on the desired cut for the
application, See the chart below for correct angle settings
and correct positioning of crown molding on miter table,
The settings in the chart below can be used for cutting All
Standard (U,S,) crown molding with 52 and 38 angles, The
crown molding is placed flat on the miter table using the
compound features of your miter saw,
CEILING
FENCE
TOPEDGEAGAINSTFENCE=
• LEFTSIDE,INSIDECORNER
• RIGHTSIDE,OUTSIDECORNER
MITERTABLE
INSIDE
CORNER
FENCE OUTSIDE
CORNER
BOTTOMEDGEAGAINSTFENCE=
• RIGHTSIDE,INSIDECORNER
• LEFTSIDE,OUTSIDECORNER
MITERTABLE
CROWNMOLDINGFLATONMITERTABLE
Fig. 31 ,_
Page 24
Loading ...
Loading ...
Loading ...