Loading ...
Loading ...
Loading ...
02
15
Connecting an AV receiver
or amplifi er using an optical
digital audio cable
UT
Red
White
AV receiver
or amplifier
Direction of signal flow
To optical digital
audio input terminal
Optical digital audio
cable (commercially
available)
2-channel
analog audio
can also be
connected.
Rear panel
To audio
input
terminals
Audio cable
(commercially available)
Connecting components to
the USB port
About USB devices
The USB devices that can be connected to the
player are as shown below.
• USB 2.0-compatible USB fl ash drive
(capacity of 1 GB or greater, 2 GB or
greater recommended) or HDD (capacity 2
TB or less)
• File system: FAT16, FAT32 or NTFS
Notes:
• It cannot be used when initialization is done
with a fi le system other than FAT16, FAT32
or NTFS.
• USB devices may not be recognized if they
contain multiple partitions.
• Some USB devices may not operate with
this player.
• Operation of USB devices is not
guaranteed.
Connecting the USB device
Notes:
• Be sure to turn the player’s power off
before connecting or disconnecting USB
devices.
• When using an external hard disk as the
external storage device, be sure to turn on
the hard disk’s power before turning on the
player's power.
• If the USB device is write-protected, be
sure to disable the write-protection.
• When connecting the USB cable, hold onto
the plug, set the plug in the proper direction
for the port and insert it horizontally.
• Placing excessive loads on the plug may
result in poor contact, making it impossible
to write data on the USB device.
• When a USB device is connected and the
player’s power is turned on, do not unplug
the power cord.
Notes:
• Devices may not work if connected to the
USB port via a memory card reader or USB
hub.
• Use a USB cable with a length of 2 meters
or less.
Loading ...
Loading ...
Loading ...