Loading ...
Loading ...
Loading ...
6 7
Installation
Installation Location & Wiring
BUILT-IN INSTALLATION
Select Location
The proper location will ensure peak performance of your appliance. Choose a location where
the unit will be out of direct sunlight and away from heat sources. Units with fan cooled
condensers can be built-in.
Unit should be operated in a properly ventilated area with ambient temperatures above
40°F (4.4°C) and below 110°F (43°C). Installation should be such that the cabinet can be
moved for servicing if necessary.
Cabinet Clearance
Ventilation is required from the bottom front section of the unit. Keep this area open and clear
of any obstructions. The adjacent cabinets and countertop can be built around the unit as
long as no top trim or counter top is installed lower than the top of the hinge.
ELECTRICAL CONNECTION
Electrical Requirements
A 115 volt, 60 Hz, AC only 15 amp fused electrical supply is
required. (A time delay fuse or circuit breaker is recommended.)
It is recommended that a separate circuit, serving only this
appliance, be provided.
• ELECTRICAL GROUND IS REQUIRED ON THIS APPLIANCE.
• DO NOT UNDER ANY CIRCUMSTANCES REMOVE THE
POWER SUPPLY CORD GROUND PLUG.
• DO NOT USE AN EXTENSION CORD.
Recommended Grounding Methods
For your personal safety, this unit must be grounded. This
appliance is equipped with a power supply cord having a
3-prong grounding plug. To minimize possible shock
hazard, the cord must be plugged into a mating 3-prong
grounding type wall receptacle grounded in accordance
with the National Electrical Code and local codes and
ordinances. If the circuit does not have a grounding type
receptacle, it is the responsibility and obligation of the
customer to exchange the existing receptacle in
accordance with the National Electrical Code and
applicable local codes and ordinances. The third ground
plug SHOULD NOT, under any circumstances, be cut or
removed. All UL listed refrigerated products are equipped
with this type of plug.
Power Supply
with 3-prong
grounding plug
Grounding type
wall receptacle
WARNING
ELECTRICAL SHOCK
HAZARD
Improper grounding can result in
a risk of electric shock.
Consult a qualified electrician if the
grounding instructions are not completely
understood, or if doubt exists as to
whether the appliance is properly
grounded. DO NOT use an extension
cord. If the power supply cord is too short,
have a qualified electrician install an outlet
near the appliance.
Lock and Unlock
CASTERS
Your beverage dispenser is equipped with four casters.
The front two casters can be locked.
For built-in applications, the four casters can be
removed by removing the nut located inside the
dispenser cabinet and then pulling the threaded caster
spindle through the base of the unit.
CABINET CUTOUT - PORTABLE MODELS - VRBD
2
4
”
(
6
1
.
0
c
m
)
24”
(
61.0 cm)*
24-3/4”
(62.9 cm)
35-9/16”
(90.3 cm)**
*24” width for cabinet only. 24-1/4” (61.6 cm)
needed for cabinet and door width clearance
if door is recessed between cabinets.
**35-9/16” (90.3 cm) height is without casters
mounted to unit. 39-3/4” (101.0 cm)
needed for height clearance with casters.
LEVEL UNIT
1. After placing unit in position, check to make certain that the unit is level side to side and front to back.
2. Accurate leveling is essential for proper operation.
NOTE: If removing casters for installation, the unit should
be raised off the ground. This should be done with an
approved material. (Consult local building codes for
approved material.)
Loading ...
Loading ...
Loading ...