Loading ...
Loading ...
Loading ...
CONNECTION TO THE POWER SUPPLY - AGA TC3
Electric Shock Hazard
Rating Plate is located behind removable plinth, see Fig. 4.
Electrical Grounding is required on this appliance.
DO NOT connect to the electrical supply until the appliance is permanently grounded.
Disconnect the power to the junction box before making the electrical connection.
This appliance must be connected to a grounded metallic permanent supply or a
grounding connector should be connected to the grounding terminal or wire lead on the
appliance.
Failure to follow these instructions could result in death or serious injury.
This range must be supplied with a 240V, 60Hz power supply and connected to an individual,
properly grounded branch circuit protected by a circuit breaker or time delay fuse. At 240V, it has
a maximum load of 36 amps. Electric hook-up must be done by a licensed electrician. This unit
must be installed according to local code, or in the absence of local codes, the National Electrical
Code for the country of installation.
Wire sizes (COPPER WIRE ONLY) and connections must conform with the rating of the range
(36-amperes).
l Product installation requires a separate (not shared) 240v/40 amp circuit protected by an
appropriate branch circuit supply.
l A time-delay fuse or circuit breaker is required.
l The service cord provided on your product is fitted with a standard four (4) conductor type
14-50P plug, (matching receptacle 14-50R).
l The wiring diagram is located on Page 18.
The method of connection to the mains electricity supply must facilitate complete electrical
isolation of the appliance.
The mains connection and isolation should not be positioned above the range and must be
positioned within the area defined in Fig. 4, Page 10.
THIS APPLIANCE MUST BE COMPLETELY ISOLATED FROM THE ELECTRICITY SUPPLY
BEFORE SERVICING. THE APPLIANCE IS DESIGNED FOR THE VOLTAGE STATED ON
THE RATING PLATE, WHICH IS SITUATED BEHIND THE PLINTH COVER.
8
Loading ...
Loading ...
Loading ...