Loading ...
Loading ...
Loading ...
13
WHAT TO DO IN CASE OF A PROBLEM
When the symbol [ E 4 ] appears :
• The table must be reconfigured. Please implement the following steps:
I) Make sure there is no more pot on the hob.
II) disconnect the appliance from the grid by removing the fuse or turning the circuit
breaker off.
III) Reconnect the table to the grid.
IV) Procedure
• If [ E 4 ] displaying remains, please call the customer care
The hob or the cooking zone doesn’t start-up :
• The hob is badly connected on the electrical network.
• The protection fuse cut-off.
• The locking function is activated.
• The sensitive keys are covered with grease or water.
• An object is put on a key.
The control panel displays [ U ] :
• There is no pan on the cooking zone.
• The pan is not compatible with induction.
• The bottom diameter of the pan is too small.
The control panel displays [ E ] :
• Call the After-sales Service.
a
b
start the procedure within 2 minutes after reconnecting the hob to the grid
don’t use the [ ] touch
VI) Second step: new setup
1) Take a ferromagnetical pot with a minimum diameter of 16 cm
2) Place the pot on the area to be set
3) Select a cooking zone by pushing on the corresponding [ O ] key
4) Wait until the [ C ] display becomes a [ - ]. The selected zone is now configured.
5) Follow the same procedure for each cooking zone with a [ C ] display.
6) All the cooking zones are configured once all the displays are turned off.
Please use the same pot for the whole procedure.
Never put several pots together on the zones during the setup-process.
V) First step: cancel the existing configuration
1) Press [ - ] and hold down
2) With your other hand, press successively
and within
(less than 2s) on each [ O ] key.
Begin from the front right side and then the left
side as per picture
A double "beep" means an error occurred.
If so, start again from item 1).
3) Remove your fingers from the touch control, press simultaneously [ + ] and [ - ]
during few seconds, until blinking [ E ] symbols appear.
4) Wait until [ E ] symbols stop blinking.
5) After few seconds, [ E ] are automatically converts into [ C ]. The existing setup
has now been cancelled.
Loading ...
Loading ...
Loading ...