Loading ...
Loading ...
Loading ...
W415-2841 / E / 12.22.20
EN
20
finishing
• Power supply service must be completed prior to finishing to avoid reconstruction.
• Heat vents and air openings cannot be covered in any circumstances.
!
WARNING
4.0 finishing
4.1 crystal ember installation
4.2 optional topaz glass chips and driftwood log installation
(NEFL42/50/60/74/100CHD-1 only)
The front glass must be removed and the appliance must be secured in its final location before the optional
topaz glass chips and driftwood logs are installed (CHD-1 models only) (see “front glass installation and removal”
section).
Recommended driftwood log placement for NEFL50CHD-1
The front glass must be removed and the appliance
must be secured in its final location before the crystal
embers are installed (see “front glass installation and
removal” section).
1. Remove the 2 screws from the plastic ember bed
panel before applying crystal embers and/or logs to
keep the ember bed panel plat (Fig. 4-1).
2. Carefully place crystal embers into the bottom
media tray (Fig. 4-2).
3. Apply an even layer from side to side.
4. Randomly place the large crystal embers
on top of the small crystal embers (for
NEFL42/50/60/74/100CHD-1 only).
1. Carefully place driftwood logs on the media tray.
2. Use the topaz glass chips to fill in spaces between the driftwood logs. This will improve the overall look of the
appliance.
Fig. 4-2
Recommended driftwood log placement for NEFL42CHD-1
A
A
A1
B
B1
C1
C
D
Reference Log Number
A W135-0728-SER
A1 W135-0728-SER Rear Side
B W135-0729-SER
B1 W135-0729-SER Rear Side
C W135-0730-SER
C1 W135-0730-SER Rear Side
D W135-0731-SER
Fig. 4-1
Loading ...
Loading ...
Loading ...