Loading ...
Loading ...
Loading ...
LOWER
BLADEGUARD
PHILLIPS
SCREW
BOLTCOVER
TO
ONSPINDLE
INNERBLADE
WASHERW_H
DOUBLE"D"FLATS
BLADE
TIGHTEN
BLADEBOLT
:)LITERBLADEWASHER
WITHDOUBLE"D" FLATS
Fig. 11
• Depress the spindle lockbutton and rotatethe
blade boltuntilthe spindle locks.See Figure 12.
• Usingthe blade wrench provided,loosen and
remove the blade bolt.
Note: The blade bolthas left handthreads. Turn
blade boltclOCkwiseto loosen.
• Remove outer blade washer. Do not remove
inner blade washer.
SPINDLE
BUTTON
Fig. 12
• Wipe a drop ofoil ontoinner blade washer and
outerblade washer where theycontact the blade.
,_ WARNING: Ifinner blade washer has been
removed, replace itbefore placing blade on
spindle. Failureto do so couldcause an accident
since blade wil_nottighten properly,
• Fit saw blade inside lower blade guard and onto
spindle.The blade teeth point downward at the
front of saw as shown in figure 11.
CAUTION: Always instaIJthe blade with the
blade teeth and the arrowprinted on the side of
the blade pointing down at the front of the saw,
The direction of blade rotation is also stamped
with an arrow on the upper blade guard.
• Replace outer blade washer, The double "D"flats
on the blade washers align with the flats on the
spindle.
• Depress spindle lock button and replace blade
bolt.
Note: The blade bolt has left hand threads. Turn
blade bolt counterclockwise to tighten.
• Tighten bladeboltsecurely.
• Remove the blade wrench and store it in a safe
place for future use.
• Replace the lower blade guard and blade bolt
cover.
• Retighten phillips screw securing blade bolt cover.
Tighten screw securely. See Figure 11.
_. WARNING: Make sure the spindlelock button is
not engaged before reconnecting saw intopower
source, Never engage spindlelockbuttonwhen
blade is rotating.
Yourcompound miter saw has been adjusted at the
factory for makingvery accurate cuts. However, some
ofthe componentsmight have been jarred out of
alignment duringshipping.Also, over a periodoftime,
readjustmentwill probablybecome necessary due to
wear. After unpackingyoursaw, check the following
adjustments before you begin usingsaw. Make any
readjustments that are necessary and periodically
check the parts alignment to make sure that your saw
is cutting accurately.
_. WARNING: Your saw shouldnever be
connected to powersupply when you are
assemblingparts, makingadjustments,installing
or removingblades, or when not in use.
Disconnectingyour saw willprevent accidental
starting that could cause serious injury.
14
Loading ...
Loading ...
Loading ...