Loading ...
Loading ...
Loading ...
Before Use
9
Before Use
PREPARE YOUR IRONING BOARD
• Remove the iron from the iron protection cover.
• Plug the iron cable into the board steam socket.
• Put the iron (soleplate down) on the rest pad.
FILL THE TANK WITH WATER
• Ensure that the electrical cable is
disconnected from the power socket.
• Slide the iron rest pad out horizontally to
access the boiler cap.
• Unscrew and remove the safety boiler cap
carefully, ensuring that no steam is present.
• Fill the bottle with ordinary tap water.
• Put the bottle into the hole for lling the steam generator tank
and push it down to release the water to go in.
• Carefully screw in the safety cap without forcing it too much
(tightening too hard is not necessary and may cause the gasket to
wear out).
• Close the iron rest pad. Iron only when the iron rest pad is in
the closed position.
Important! The maximum capacity of the steam generator is 0.8L.
Do not forget that residual water is always left in the tank. When
water is poured, air bubbles in the lling-hole of the steam generator
can hinder the subsequent lling. Therefore, we recommend that
you slightly move the bottle from side to side during lling. Never
ll the steam generator directly from the tap: spilled water could
cause a short circuit!
TAP
WATER
PRESS LIGHTLY CLOSE THE IRON
REST PAD
Loading ...
Loading ...
Loading ...